Table of Contents
Advertisement
When pressing the
measurement stops and "
When pressing the START key again, the Leak Tester judges the measurement
result ("
"/"
When finishing the measurement, remove the pipette
from the tip of the attachment.
If the pipette has the ejector (for releasing the tip),
remove the pipette by operating the ejector.
When measuring another pipette, press the START
key again after connecting the pipette to be measured
(return to "(2) Starting measurement"). The leak tester
starts the measurement. At this time, the display is the
measurement result.
* When kept in a state of having the air evacuated,
in the case of not removing the pipette, the pump
does not operate again.
(4) Measurement end
When finishing the pipette measurement, Press the ON:OFF key to turn the power
supply off (after "
AC adapter from the main unit.
For storing, refer to
START
key, while in the middle of a measurement, the
" is displayed.
") after operating the pump again.
" is displayed, the power supply turns off). Then, disconnect the
"10. MAINTENANCE AND
NOTES".
12
Pipette
Attachment
Advertisement
Table of Contents
