Service & Adjustments - Craftsman 24BF570L099 Operator's Manual

Table of Contents

Advertisement

Available languages

Available languages

WARNING
Do not at any time make any adjustments without first stopping
the engine, disconnecting spark plug wire and grounding it against
the engine. Always wear safety glasses during operation or while
performing any adjustments or repairs.
WEDGE ASSEmbLy ADJuSTmENT
As normal wear occurs and there is excessive "play" between the
wedge and beam, adjust the bolts on the side of the wedge assembly
to eliminate excess space between the wedge and the beam.
1. Loosen the jam nuts on the two adjustment bolts on the side of the
wedge. See Figure 16.
Adjustment Bolt
Jam Nut
2. Turn the adjustment bolts in until snug and then back them off
slowly (approximately 1.5 turns) until the wedge assembly will slide
on the beam.
3. Re-tighten the jam nuts securely against the side of the wedge to
secure the adjustment bolts in this position.
GIb ADJuSTmENT
Periodically remove and replace the "gibs" (spacers) between the
wedge assembly and the back plate.
NOTE: The gibs may be rotated and/or turned over for even wear.
1. Loosen the lock nuts under each back plate and slide the gibs out.
See Figure 16.
2. Turn or replace the gibs.
3. Reassemble the back plate and secure with the lock nuts.
4. Readjust the bolts on the side of the wedge assembly.
hoSE CLAmpS
• Before each use check all the hose clamps to see if they are tight.
SERVICE & ADJUSTMENTS
Gib
Lock Nut
Figure 16
FLExIbLE pump CoupLER
The flexible pump coupler is a nylon "spider" insert, located between
the pump and the engine shaft. Over time, the coupler will harden and
deteriorate. If you detect vibration or noise coming from the area be-
tween the engine and the pump contact an authorized service dealer.
If the coupler fails completely, you will experience a loss of power.
TIRES
The maximum pressure for the tires is 30 psi. Do not exceed the
manufacturer's recommended psi under any circumstances. Maintain
equal pressure on all tires.
Excessive pressure when seating beads may cause the tire/rim
assembly to burst with force sufficient to cause serious injury. Refer to
sidewall of the tire for the recommended pressure.
14
WARNING

Advertisement

Table of Contents
loading

This manual is also suitable for:

247.77640

Table of Contents