Table of Contents
Advertisement
7. The procedure will ask for the USB sensor to be placed on the center of the display panel (Figure S.7). Tilt the display
panel approximately 5˚ backward and place the USB sensor in the center of the display panel (Figure S.1).
NOTE:
Place the USB sensor flat against the LCD to avoid external light contamination. DO NOT press the calibrator
against the display panel. Press "SELECT".
8. Set the target LUMINANCE (cd/m
Figure S.6
9. Press "SELECT" to start the calibration. Stand-alone calibration may take several minutes depending on user settings.
10. After the CALIBRATION SUCCEEDED message appears (Figure S.9), press SELECT.
11. To end the calibration mode, press "EXIT".
2
) (Figure S.8).
Figure S.7
Figure S.9
English-26
Figure S.8
Hide quick links:
Advertisement
Table of Contents
