Remote Control - Sharp HT-SB117 Operation Manual

Controls and indicators (continued)

■ Remote control

1
2
3
4
5
6
7
8
1.
STANDBY: Press this to switch on the unit. Press it
again to put the unit in standby mode.
2.
VOLUME +: Press this to increase volume.
3.
PREVIOUS: Press this to skip to the previous track.
4.
PLAY/PAUSE: Press this to temporarily pause a
playback. Press it again to resume the playback.
Press and hold this button for 3 seconds to disconnect
Bluetooth connection.
5.
VOLUME -: Press this to decrease volume.
6.
BLUETOOTH: Press this to enter Bluetooth mode.
7.
MOVIE: Press to enter the Eq2 equalizer mode MOVIE
(recommended for viewing movies).
8.
MUSIC: Press to enter the Eq1 equalizer mode MUSIC
(recommended for listening to music).
9.
MUTE: Press this to mute the sound. Press it again
to unmute.
10.
NEXT: Press this to skip to the next track.
11.
INPUT: Press repeatedly
BLUETOOTH, LINE IN, OPTICAL, ARC or USB mode.
12.
NEWS: Press to enter the Eq3 equalizer mode that
is preset equalizers NEWS (recommended for viewing
news).
9
10
11
12
92L1CT1012674A
to switch
■ Battery installation
Fitting or replacing the remote control battery
Use 2 "AAA" size batteries (UM/SUM-4, R3, HP-16 or similar).
1. Remove the batteries compartment cover on the back
of the remote control.
2. Load two AAA/1.5V batteries into the battery
compartment making sure that the battery have been
inserted with the correct polarities matching the symbols
+, - as indicated inside the battery compartment.
3. Replace the battery cover and clip it in place.
Caution:
●
Replace all old batteries with new ones at the same
time.
●
Remove the batteries if the unit will not be used for a
long period of time. This will prevent potential damage
due to battery leakage.
●
Do not use rechargeable batteries (nickel-cadmium
battery, etc.).
●
Batteries (battery pack or batteries installed) shall not
be exposed to excessive heat such as sunshine, fire
or the like.
●
Risk of fire explosion if the battery is replaced by an
incorrect type.
Notes concerning use:
●
Exposing the sensor on the unit and remote control to
strong light may interfere with operation. Change the
lighting or the direction of the unit if this occurs.
●
Keep the remote control away from moisture, heat
shock, and vibrations.
■ Remote control operation
● Point the remote control at the remote sensor on the
front panel.
● The remote control works within a distance of about 26
ft. (8 m) from the sensor and within an angle of about
30 degrees from the left and right side.
among
E-9