Page 1
MODEL HT-SB110 SOUND BAR HOME THEATRE SYSTEM OPERATION MANUAL Thank you for purchasing this SHARP product. To obtain the best performance from this product, please read this manual carefully. It will guide you in operating your SHARP product.
Accessories The following accessories are included. Plug adaptor x 1 Remote control x 1 AC Power Cord x 1 (for Philippines only) Wall-mounting Audio cable x 1 Wall Bracket x 2 screws set x 1 Contents Page Page Accessories Connection ..............
The Bluetooth ® word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc. and any use of such marks by SHARP is under license. Other trademarks and trade names are those of their respective owners. Precautions General...
Controls and indicators Front panel Remote Control Sensor LED Indicators Red indicator: In STANDBY mode. Green indicator: In AUX mode. Orange indicator: In Optical mode. Blue indicator: In Bluetooth mode. White indicator: In HDMI ARC mode. Wall bracket screws button Switch the sound bar between ON and STANDBY mode.
Controls and indicators (continued) Remote control – Switch the sound bar between ON and STANDBY mode. MUTE – Mute or resume the sound. Function buttons – Select the input function. VOL+/VOL- – Increase/decrease the volume level. – Skip to previous/next track in Bluetooth mode. / PAIR –...
Remote control Caution: Do not use rechargeable battery (nickel-cadmium WARNING battery, etc.). Danger of explosion if battery is incorrectly replaced. DO NOT INGEST BATTERY, Replace only with the same or equivalent type. CHEMICAL BURN HAZARD Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like.
Check all wall mount angle screws for looseness. Select a good location. If not, accidents may occur or the sound bar may get damaged. SHARP is not responsible for accidents resulting from improper installation. Leave a 5mm gap between the wall and the screw’s head.
Connection Optical input HDMI ARC input Remove the protective cap of the OPTICAL socket, then The ARC (Audio Return Channel) function allows you to connect an OPTICAL cable (not included) to the TV’s send audio from your ARC- compliant TV to your sound bar OPTICAL OUT socket and the OPTICAL socket on the through a single HDMI connection.
Music (recommended for listening to music), NEWS (recommended for listening to NEWS). Select “HT-SB110 SHARP” in the pairing list. After the “Paired” voice prompt, the system is successfully connected and the blue indicator will light up.
Bluetooth operation (continued) Troubleshooting To keep the warranty valid, never try to repair the system To disconnect the Bluetooth function, you can: yourself. If you encounter problems when using this sound Switch to another function on the sound bar. bar, review the following before requesting service. Disable the Bluetooth function on your device.
Specification As part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for product improvement without prior notice. The performance specification figures indicated are nominal values of production units. There may be some deviations from these values in individual unit.
Page 12
Printed in China 92LIM203010633 18J R MW 1...