Table of Contents
Advertisement
All manuals and user guides at all-guides.com
HK-QC INSTALLATION INSTRUCTIONS
1.
Connect Hose Kit to unit by aligning the QC Coupling with the QC Fitting on the
unit. Connect the hose kit according to hose and unit labels: BLACK to WATER IN,
RED to WATER OUT and YELLOW to DRAIN. HOLD the coupling behind the sleeve
allowing the sleeve to move freely and PRESS firmly, until the sleeve retracts and
clicks. The "click" means that the QC Coupling is engaged onto the QC Fitting.
2. Connect WATER IN hose to water supply using hose connection, and sink
adapter (if needed).
3. Install WATER OUT line in drain, allowing for free drain conditions with an air
space around the opening.
4. Install DRAIN line in drain, allowing for free drain conditions.
5. Open water supply valve, and check for any water leaks in hose connections.
To release the coupling, Hold the Coupling as shown below, and pull back on the
sleeve. The Coupling will release and the valve inside of the coupling seal.
Once off-site, use the fitting secured to the hose kit by the lanyard to break the
vacuum, and drain the hoses.
High Pressure Switch Reset Button
Water
Water
Drain
Out
In
Electrical Cord
Strain-Relief
SINK ADAPTER
(use if required)
WATER CONNECTIONS
(WATER SUPPLY)
OR PLACE WATER-OUT AND DRAIN
ALLOW WATER-OUT AND DRAIN LINE TO
LINES INTO DRAIN RISER
DRAIN FREELY INTO SINK
10
Advertisement
Table of Contents
