Installation - NEC MultiSync P702 User Manual

Installation

This device cannot be used or installed without the Tabletop
Stand or other mounting accessory for support. For proper
installation it is strongly recommended to use a trained,
NEC authorized service person. Failure to follow NEC
standard mounting procedures could result in damage to the
equipment or injury to the user or installer. Product warranty
does not cover damage caused by improper installation.
Failure to follow these recommendations could result in
voiding the warranty.
In order to aid in mounting or carrying, a lifting device
must be used in conjunction with the attachable eyebolts
(M12). Do not attempt to mount or carry the display using
your own strength as the display may fall and cause
personal injury.
Attach eyebolts (M12)
This model is equipped with attachable eyebolts (M12) to aid
in mounting.
• Place the washer over the threads of the eyebolt.
• Screw the eyebolts (M12) into eyebolt holes as shown in
the picture.
• Be sure eyebolts (M12) are secure.
• In order to move the monitor into position, use a lifting
device attached to the eyebolts (M12).
DO NOT mount the monitor using only the eyebolts (M12).
Use an approved mounting accessory.
Landscape
Eyebolt (M12)
Washer for
eyebolt (M12)
Eyebolt Hole
Portrait
Eyebolt (M12)
Washer for
eyebolt (M12)
Eyebolt Hole
Mounting
DO NOT mount the monitor yourself. Please ask dealer.
For proper installation it is strongly recommended to use
a trained, qualifi ed technician. Please inspect the location
where the unit is to be mounted. Mounting on wall or ceiling
is the customer's responsibility. Not all walls or ceilings are
capable of supporting the weight of the unit. Product warranty
does not cover damage caused by improper installation,
remodelling, or natural disasters. Failure to comply with these
recommendations could result in voiding the warranty.
DO NOT block ventilated openings with mounting
accessories or other accessories.
For NEC Qualifi ed Personnel:
To ensure safe installation, use two or more brackets to
mount the unit. Mount the unit to at least two points on the
installation location.
Please note the following when mounting
on wall or ceiling
• When using mounting accessories other than those that
are NEC approved, they must comply with the VESA-
compatible (FDMlv1) mounting method.
• NEC strongly recommends
using size M8 screws
(14-16 mm + thickness
of bracket and washer in
length). If using screws
longer than 14-16 mm,
check the depth of the hole.
(Recommended Fasten
Force: 1125 - 1375 N•cm).
Bracket hole should be under ø 10 mm.
NEC recommends mounting interfaces that comply with
UL1678 standard in North America.
• Prior to mounting, inspect the installation location to
insure that it is strong enough to support the weight of the
unit so that the unit will be safe from harm.
• Refer to the instructions included with the mounting
equipment for detailed information.
• Make sure there is no gap between the monitor and
bracket.
English-5
Mounting
Unit No gap
Bracket
Washer
under
Screw
φ 10 mm
14-16 mm
Thickness
of bracket
and washer