GE Profile PTW9000 Owner's Manual & Installation Instructions page 13

PREPARING CABINET: BELOW WALL OVENS
INSTALLATION BELOW A SINGLE OVEN
2x2 or 2x4
anti-tip block
against rear
wall 9" from
floor to bottom
of block
INSTALLATION BELOW A DOUBLE OVEN
2x2 or 2x4
anti-tip block
against rear wall
9" from floor to
bottom of block
When installed, the front face of the warming
drawer will be nearly flush with cabinetry doors or
drawer fronts.
of the opening.
The rough opening for the drawer must be:
1 / " minimum from inside back to front
2
of cabinet frame.
1 / " for 27" wide models
2
28 1 / " for 30" wide models.
2
1 / "
4
cutouts for clearance of overlaps
49-2000768 Rev. 0
Installation Instructions
23 1 /
2
Min.
Oven
cutout
9"
9 / "
1
4
A
1" Min. above toekick
or adjust to oven
installation height
23 1 / "
2
Min.
Oven
Allow 5/8" overlap
cutout
on all sides
2" Min
9"
9 1 / "
4
A
1" Min. above
toekick
"
NOTE: Additional clearance between cutouts may be
required. Check to be sure that oven supports above
the warming drawer location do not obstruct the
required interior 23
2" Min.
Allow 5/8"
overlap on
23 / "
1
4
all sides
10 1 / "
2
27" Drawer
30" Drawer
NOTE: Additional clearance between
cutouts may be required. Check to be sure
that oven supports above the warming
drawer location do not obstruct the required
interior 23
23 1 / "
4
10 1 / "
2
NOTE: If you are installing in frameless cabinets, it
may be necessary to install 1/2" wide cleats to accept
drawer mounting screws. See drawer to find exact
locations of mounting screws.
When installed under a wall oven:
Warming drawers are suitable for installation below
only certain specified wall oven models. See the
label attached to the top of the warming drawer for
suitable models.
NOTE: Electrical receptacle can be installed as shown
above the top of the warming drawer cutout.
1 / " depth and 9 1 / " height.
2 4
Dimension A Dimension B
25 1 / "
2
28 1 / "
2
/ " depth and 9 / " height.
1 1
2 4
26 3 / "
4
29 3 / "
4
13