Inserting Slides - Silvercrest 307324 Operating Instructions Manual

Inserting slides

♦ Insert slides the right way round into the shaft provided on the
slide magazine
can be added to the magazine .
♦ Push the slide magazine
viewing window at the front . Ensure that the triangle marking is
at the front and visible (see figure 2) .
Use the pusher on the side of the slide magazine
slides in the shaft individually into the scanner .
♦ To do this, first slide the pusher away from the scanner as far
as the stop . Afterwards, move the pusher carefully towards the
scanner .
NOTE
► This pushes any slide that is in the scanner out of the device
and a new slide is pushed into the viewing range of the
scanner .
► Make sure that you push the new slide into the scanner
slowly . If you push too quickly, the slide could slip past the
viewing range of the scanner .
♦ When you have finished scanning slides, remove the slide maga-
zine from the slot
6
Remove the last slide from below from out of the slide magazine
viewing window
SND 3600 D3
. Around 10–12 slides (depending on size)
6
into the slot
6
.
4
.
6
on the right with the
4
to push the
6
GB │ IE │ 35 ■