Self-Test; Video Output; Network Output; Hdmi Output - Feelworld UHD4K12X User Manual

1.2.2 Self-Test

After power on, the receiver light will start flashing and camera will do a brief pan-tilt
tour and return to the home position. When light stop flashing, the self-test is finished.
 Default address of the remote control is 1#. When menu restore default setting, the
address of IP remote control will restore 1#.
 If preset 0 is set, the camera will return to the preset 0 position after self-test

1.3 Video Output

This series camera can output video through network, HDMI, and USB-C 3.0.

1.3.1 Network Output

a, Network connection: Shown as diagram 1.1 #11
b, Log in: You can reach the Web Interface by typing in the camera's IP
address(default 192.168.5.163) into a web browser. To log in, type in "admin" into the
username and password fields. From the Web Interface, you can adjust many of your
camera's settings via this IP interface, like PTZ control, and configuration setting.

1.3.2 HDMI Output

a, HDMI connection: Shown as diagram 1.1 #8
b, Connect camera to the display device via HDMI cable.
1.3.3 USB-C 3.0 Output
USB-C3.0 connection: Shown as diagram 1.1 #7. Open video software and select
image device to output video.

1.4 Bracket

 Bracket can only be wall mounted or upside down mounted on template and
concrete wall, but can not be installed on plasterboard.

1.4.1 Steps of Wall Mount

4K PTZ Camera  User Manual
2