Grizzly G0555 Owner's Manual page 22

15. Attach the front fence rail to the table with
the (2) M6-1 x 20 hex bolts, (2) 6mm lock
washers, and (2) 6mm flat washers (see
Figure 18).
Note: There is a small amount of vertical play
in the rail holes. Make sure to position the
rail evenly along its length before tightening
the hex bolts. This will allow the fence to ride
across the table with the proper amount of
clearance.
Figure 18. Attaching the front fence rail.
16. Attach the rear fence rail to the table with
the (2) black M6-1 x 16 cap screws (see
Figure 19).
Figure 19. Attaching the rear fence rail.
-20-
Use This Set
of Threaded Holes
17. Thread (1) M8-1.25 hex nut onto the fence
lock handle, then thread the handle into the
fence and secure it in place by tightening the
hex nut against the fence.
18. Move the fence lock handle up, position
the fence face between the column and the
blade, as shown in Figure 20, then place it
onto the front fence rail.
Figure 20. Placing the fence onto the rails.
19. Thread the M6-1 hex nut onto the fence
stand-off, then thread it into the rear under-
side of the fence (see Figure 21) so that
the fence rests the same height above the
table along its full length. Tighten the hex nut
against the fence to secure the setting.
Stand-Off
Figure 21. Fence stand-off installed.
Model G0555 (Mfd. Since 5/11)