Compliance With Weee Directive; Appropriate Installation Location - Jocel JLR014092 Instruction Manual

power cable and break the locking mechanism of the loading door so that it will be non-functional
before disposing of the product.

COMPLIANCE WITH WEEE DIRECTIVE

This product complies with EU WEEE Directive (2012/19/EU). This product bears a
classification symbol for waste electrical and electronic equipment (WEEE).
This product has been manufactured with high quality parts and materials which can be
reused and are suitable for recycling. Do not dispose of the waste product with normal
domestic and other wastes at the end of its service life. Take it to the collection center for
the recycling of electrical and electronic equipment. Please consult your local authorities to learn
about these collection centers.
Compliance with RoHS Directive:
The product you have purchased complies with EU RoHS Directive (2011/65/EU). It does not
contain harmful and prohibited materials specified in the Directive.
INSTALLATION
This product must be installed by an accredited technician. To make the product ready for use,
review the information in the user manual and make sure that the electricity, tap water supply and
water drainage systems are appropriate before calling the Technical Assistance. If they are not, call
a qualified technician and plumber to have any necessary arrangements carried out.
Preparation of the location and electrical, tap water and waste water installations at the
place of installation is under customer's responsibility.
Make sure that the water inlet and discharge hoses as well as the power cable are not
folded, pinched or crushed while pushing the product into its place after installation or
cleaning procedures.
WARNING: Installation and electrical connections of the product must be carried out by
the Authorized Service Agent. Manufacturer shall not be held liable for damages that
may arise from procedures carried out by unauthorized persons.
WARNING: Prior to installation, visually check if the product has any defects on it. If so,
do not have it installed. Damaged products cause risks for your safety.

APPROPRIATE INSTALLATION LOCATION

• Place the machine on a rigid floor. Do not place it on a long pile rug or similar surfaces.
• Place the product on a solid and flat floor that has sufficient load carrying capacity!
• Do not place the product on the power cable.
• Do not install the product at places where temperature may fall below 0ºC.
• Place the product at least 1 cm away from the edges of other furniture.
69