Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Russell Taylors V10i
Summary of Contents for Russell Taylors V10i
- Page 1 WET & DRY VACUUM CLEANER USER MANUAL V10i...
-
Page 2: Table Of Contents
Contents 1.Safety Instructions ..........................1 1.1 Warning ...............................1 1.2 Safety Instruction ..........................2 2.Product Introduction ..........................3 2.1 Product Component ..........................3 2.2 Charging Base ............................4 2.3 Accessories ............................4 2.4 Status Display ............................5 2.5 Display Light Details .........................5 2.6 Voice Indicator ...........................6 3.Product Assembly ...........................7 3.1 Install the handle ..........................7 3.2 Remove the handle ..........................7 4.Product Operation ..........................8... -
Page 3: Safety Instructions
1.Safety Instructions or other heavy dirty conditions. Please do not use the device to clean cement, gypsum powder,wall powder and other small particles that are water tank. immediately to clean up the wires to avoid damage to the machine. Please do not put the machine sideways or upside down.Please clean the dirty water tank in time after using. If the machine is not used for a long time, please ensure that it is charged at least every three months. -
Page 4: Safety Instruction
1.Safety Instructions 1.2 Use Restrictions carpet or other non waterproof ground. cleaning. Be careful not to press on the power cord when using the device to prevent... -
Page 5: Product Introduction
2.Product Introduction 2.1 Product Components Mode Button Water Spray Button Handle Handle Removal Button Clean Water Release Button Clean Water Tank Indicator Sewage Tank Release Voice Button Sewage Tank Front Cover Release Button Front Cover Charging Pins Roller Brush... -
Page 6: Charging Base
2.Product Introduction 2.1 Charging Base Charging Pins Power Port 2.2 Accessories Adapter Instruction Manual Sponge Filter... -
Page 7: Status Display
2.Product Introduction 2.4 Status Display Green Battery>40% Orange 2.5 Display Light Details Machine Status Machine Status Display light status Display light status Low battery Fan abnormal Red light for 10 seconds and then turns off. Battery fully Abnormal roller red light flashes for 5 seconds and then charged brush and then turns off. -
Page 8: Voice Indicator
2.Product Introduction 2.6 Voice Indicator Voice activation condition Voice Content (English) Start cleaning Press the Start switch Powerful mode Auto mode Please empty the dirty water tank. Dirty tank full Clean water shortage Clean water tank is Empty. Start charging Put it on the charging stand. -
Page 9: Product Assembly
3.Product Assembly 3.1 Installing the handle Insert the handle into the corresponding top position of the fuselage in the direction shown 3.2 Removing the handle in the figure to hold the handle removal key, and at the same time pull out the handle vertically upward. -
Page 10: Product Operation
4.Product Operation 4.1 Fill water to clean water tank Lift up and turn clockwise. Put the clean water tank remove the solution tank. the installation is successful when you hear Turn counterclockwise first, then press down... -
Page 11: Wash The Floor
4.Product Operation 4.2 Wash the floor Press start switch, turn on the washer , start AUTO mode. working. When the machine is running, press the spraying. turning it on. After using the placed upright... -
Page 12: Charging
4.Product Operation 4.3 Charging Connect the power adapter to the Put the wahser into the charging Insert direction 4.4 Self-cleaning sewage tank first, and make sure that the clean water tank has enough water, press finish cleaning and drying in 1 minute, and then stop automatically. -
Page 13: Product Routine Cleaning
5. Prodcut Routine Cleaning 5.1 Dirty Water Tank Clean Remove the tank cover. water tank. Pour out sewage. Take out the filter holder. Pour out solid waste. Install the water tank cover, put the sewage... -
Page 14: Cotton Filter Of Dirty Water Tank Clean
5. Prodcut Routine Cleaning 5.2 Cotton filter of dirty water tank clean Take out cotton filter support from water Open the stand cover. tank cover. Take out the filter sponge, the filter sponge After washing the filter sponge, you can dry water. -
Page 15: Roller Brush Clean
5. Prodcut Routine Cleaning 5.3 Roller brush clean front cover. Washing the rollers manually. to remove tangled hair. Shake off surface moisture. stand for drying. -
Page 16: Product Specification
6.Common Fault When the machine does not work properly, please refer to the following to handle the abnormal situation. Main Failure Failure cause and solutions charging. work. 3. The sewage tank is full, please clean the sewage tank. Suction drop time.
Need help?
Do you have a question about the V10i and is the answer not in the manual?
Questions and answers