Problem Solving Guide; Technical Problems - Miele G 5000 SC BRWS Operating Instructions Manual

Problem solving guide

Many malfunctions and minor faults that can occur in daily operation can be
corrected without contacting Miele. This will save you time and money because
you will not need a service call.
You can find information on how to remedy faults yourself at www.miele.com/
service.
Please note, however, that a call-out charge will be applied to unnecessary service
visits where the problem could have been rectified as described in these operating
instructions.
This section only lists faults that you can remedy yourself. All other faults are
shown in 
Fault FXX

Technical problems

Problem
The control panel
remains dark after the
dishwasher has been
switched on with the 
button.
The  button does not
respond immediately or
only responds once it
has been pressed
several times.
The dishwasher stops
during a programme.
78
.
Possible cause and remedy
The dishwasher is not plugged in or the socket is not
switched on.
 Insert the plug and switch on at the socket.
The circuit breaker has tripped.
 Reset the circuit breaker in the mains fuse box
(see data plate for minimum fuse rating).
 If the circuit breaker trips again, call Miele.
Energy management: the door was opened or closed
shortly before the  button was pressed. As a result,
the dishwasher was already switched on. The
electronics require a few seconds to be ready for
operation.
 Wait a few seconds after opening or closing the
door.
 Then press the  button.
The circuit breaker has tripped.
 Reset the circuit breaker in the mains fuse box
(see data plate for minimum fuse rating).
 If the circuit breaker trips again, call Miele.