Audio Settings; Troubleshooting - Panasonic 1000-RI0160U Operating Instructions Manual

Mp3 cd player/receiver
Table of Contents

Advertisement

Audio Settings

[VOL]
selects a value in the audio menu.
(PUSH SEL : Select)
selects items in the audio menu.
1
Press [VOL] (PUSH SEL) to open the audio menu.
Note: If no operation takes place for more than 5 seconds in audio setting (2 seconds in the volume adjustment), the dis
play returns to the regular mode.
2
Press [VOL] (PUSH SEL) to select a mode to be
adjusted.
Volume
(Setting Range: 0 to 40, Default: 18)
Bass
(Setting Range: −12 dB to +12 dB by 2 dB, Default: 0 dB) q / w : Adjustment
Treble
(Setting Range: −12 dB to +12 dB by 2 dB, Default: 0 dB) q / w : Adjustment
Balance
(Setting Range: 15 levels each, Default: CNT (center))
Fader
(Setting Range: 15 levels each, Default: CNT (center))
Notes:
¡ The volume can also be adjusted directly using [VOL] on the main unit. (a "General")
¡ Do not activate SQ and Bass/Treble at the same time to avoid causing sound distortion.
¡ If the fader is set to front, the pre-amp. output (rear) is decreased.
3
Turn [VOL] clockwise (q ) or counterclockwise (w)
to adjust.
q / w : Adjustment
q / w : Adjustment
q / w : Adjustment

Troubleshooting

If You Suspect Something Wrong
Check and take steps as described below.
If the described suggestions do not solve the problem, it is
recommended to take the unit to your nearest authorized
Panasonic Service Center. The product should be serviced
only by qualified personnel. Please refer the checking and
the repair to professionals.
Panasonic shall not be liable for any accidents arising out
of neglect of checking the unit or your own repair after
your checking.
Never take measures especially those other than indicated by italic letters in "Possible Solution" described below
-
because those are too dangerous for users to handle themselves.
Trouble
Possible Solution
Common
No power
¡ Start the engine. (Alternatively, turn the igni
tion switch to the ACC position.)
¡ Verify the wiring. (Battery lead, power lead,
ground lead, etc.)
¡ Fuse blown (Consult your dealer or an autho
rized Panasonic Service Center.)
¡ Ask a professional for fuse replacement.
¡ Be sure to use the same rated fuse.
No sound
¡ Disable the mute function.
¡ Verify the wiring.
¡ Wait until the dew disappears before turning
on the unit.
Noise
¡ Make sure that grounding is established
properly.
No sound from
¡ Adjust the balance and fader.
¡ Verify the wiring.
left, right, front,
or rear speaker
Left and right
¡ Connect the speaker lead correctly.
sounds are
reversed
Disc Player
No sound, or
¡ Load the disc correctly.
¡ Clean the disc.
disc is automati-
cally ejected
Sound skip, poor
¡ Clean the disc.
sound quality
Sound skip due
¡ The maximum permissible tilt angle is 30°.
¡ Secure the unit.
to vibration
Disc not eject-
¡ Press [u ]. If the disc is still not ejected, con -
sult your dealer or an authorized Panasonic
able
Service Center.
Radio
Frequent noise
¡ Tune in to another station of high-intensity
waves.
¡ Make sure that the antenna mounted point
is grounded properly.
Preset data
¡ The preset memory is cleared to return to
the original factory setting when the power
deleted
connector or battery is disconnected.
Warning
¡ Do not use the unit in an irregular condition, for ex
ample, without sound, or with smoke or a foul smell,
which can cause ignition or electric shock. Immedi -
ately stop using the unit and consult your dealer.
¡ Never try to repair the unit by yourself because it is
dangerous to do so.
Error Display Messages
Display/Trouble
Possible Solution
-
Radio
¡ Switch the power or ACC
ON/OFF. If this does not
solve the problem or the
No operation by some cause.
-
unit is still out of order,
consult your dealer or
an authorized Panasonic
Service Center to ask for
repairs.
Disc Player
¡ Check the disc.
(The disc is ejected automatically.)
The disc is dirty or upside down.
¡ Check the disc.
(The disc is ejected automatically.)
The disc has scratches.
¡ If normal operation is not
restored, consult your
dealer or an authorized
No operation by some cause
Panasonic Service
Center to ask for repairs.
¡ Check the disc.
Cannot read the file
-

Advertisement

Table of Contents
loading

Table of Contents