Skoda Rapid 2013 Owner's Manual page 127

For this purpose, the electronic control units continuously evaluate vehicle-rela-
ted data while driving. In case of operational faults and deviations from the nomi-
nal values, only these data are stored. Faults are usually indicated by the indicator
lights in the instrument cluster.
Data stored in the control units can only be read and evaluated by special equip-
ment.
Only by storing the relevant data is a specialist garage able to identify and rectify
problems that have occurred. The stored information may include the following
data:
›
engine- and gearbox-related data;
›
vehicle speed;
›
driving direction;
›
braking power;
›
seat belt query.
Under no circumstances are conversations in the vehicle recorded by the built-in
control units.
In vehicles with an alarm function via mobile phone or other connected devices,
the current location may be transmitted. In case of accidents in which the control
units recognise the deployment of one or more airbags, the system may automat-
ically transmit a signal. This depends on the service provider. In principle, the
transmission will only work in areas with adequate mobile network coverage.
Event data recorder
The vehicle is not equipped with an event data recorder.
An event data recorder temporarily stores information on the vehicle. In an acci-
dent, this will allow a detailed understanding of how the accident happened. In
vehicles with an airbag system, accident-related data such as impact velocity,
seat belt buckle statuses, seat positions, and deployment times may be stored.
The type of data that is recorded varies depending on the manufacturer.
The installation of such an event data recorder may be made only with the con-
sent of the owner and is regulated by law in some countries.
Reprogramming of control units
Basically, all data for the control of components are stored in the control units.
Some convenience functions, such as convenience flashing, single door opening,
and displays, can be reprogrammed using special workshop equipment. In this
case, the relevant information and descriptions in this Owner's Manual will no
longer match the original functions. ŠKODA recommends that you have the re-
programming registered in the service schedule under "Other workshop entries".
Information on possible reprogramming options can be obtained from your ŠKO-
DA Partner.
Reading out the fault memory of the vehicle
There is a diagnostic port in the passenger compartment for reading out the fault
memory. The fault memory documents the problems and deviations encountered
from the nominal valuesof the electronic control units.
The diagnostic connector port is located behind a cover in the footwell on the
driver's side next to the lever to open the bonnet.
The fault memory should be read out and reset only by a specialist garage.
Accessories, changes and replacement of parts

125