QCY T6 - TWS Bluetooth Earbuds Manual

Overview

Choose Your Eartips
Please try medium eartips first as they fit most people.

How to Pair

First Time Pairing:

1. Pick up both earbuds, pop both earbuds into the case to activate them.
2. On cellphone, search for QCY-T6 and tap to connect.
   *Once paired earbuds will auto power on upon picking up from the case. If earbuds fail to auto power on, please charge them and try again.

Switch Paired Device:

1. Turn off phoneA's Bluetooth faculty and earbuds will auto disconnect and enter into pairing mode.
2. On phoneB, search for QCY-T6 and tap to connect.
   *Multi-point connection is not available. Earbuds will auto reconnect to phoneB upon powering up again.
   

Factory Setting

(Try the following steps to fix connectivity issue)
Set to factory:

1. On cellphone, search for QCY-T6, tap and choose ignore or cancel pairing.
2. Pick up two earbuds, keep touching both bars for 8s or until LEDs glow red for 2s to power off.
3. Keep touching both bars for 10s or until LEDs blink red and green 3 times then blink red to set earbuds to factory.
   *Please refer "First Time Pairing" to connect after factory setting.

Manual Pairing (please refer the following steps in case two earbuds lose connection)
Power off earbuds then keep touching panels for 5s or until LEDs blink red and green. After then, double touch panels and LEDs will blink red and green. Two earbuds will then auto pair with each other when LED on master earbud blinks red and green and the other one turns off.

How to Wear

1. Rotate earbud and pop it into your ear then shake head to check wearing stability.
2. Please adjust mic towards your mouth to gain better calling experience.

Three-way Calling & Switch

Double touch the bar to answer incoming call. If another call is coming in sync, double touch again to put the first call on hold while activating the second one or keep touching the bar for 2s to ignore the second call. Keep touching the bar for 2s to switch between active call and held call.

Mono Mode

1. Power off earbuds, hold Touch Panel on either earbud for 5s to enter pairing mode(LED blinks red and green )
2. On cellphone, search for QCY-T6 and tap to connect
3. Connected

Charging Earbud

Push earbud into the case to charge. LED will glow solid red when charging and turn to green for 1 minute once top up.

Charging the Case

LED on the case will glow solid red when battery level is under 60%; LED will turn green when battery level is between 60% and 95 and become solid blue when the battery level is over 95%.

Product Parameters

Model: In1947
Bluetooth version: V5.0
Charging time: approx. 2hr
Talking time: approx. 5.5hr
Operation range: 10m(with no obstacle)
Battery type: li-ion
Battery capacity(earbud):3.7V 60mAh
Battery capacity(charging case):3.7V 600mAh
Input parameter(charging case):5V 600mA
Bluetooth profiles: HSP/HFP/A2DP/AVRCP
Pairing name: QCY-T6
Stand time: approx. 100hr
Music time: approx. 6 hr

Function Introduction