Gas Supply - Hisense HFG3601CPS Instructions For Installation Manual

Gas supply

WARNING!
Fire Hazard: Do not use a flame to check for gas-tightness.
WARNING!
Explosion Hazard: Do not use excessive torque when making gas line connections.
Excessive torque can damage gas pressure regulator and other gas line components.
Gas pressure Regulator
Appliance is supplied with gas pressure regulator which is pre-set to operate with natural gas at 4
of W.C. and can be converted to 10 of W.C. for liquid propane gas.
Inlet gas pressure must be between below range for proper operation of the appliance:
Natural gas:
From 6 of W.C. to 13 of W.C.
Liquid propane gas:
From 11 of W.C. to 13 of W.C.
Before removing your old appliance make sure the main shut-off valve is closed and appliance free
of gas.
It is recommended to use certified flexible metal connection unless hard-piped connection is required.
Main shut-off valve must be installed in such a place that it is accessible outside of the appliance.
Gas pressure regulator is located on lower back side of the appliance, the inlet internal thread is ½
NPT.
After installation make sure with test that all connections are gas-tight.
Installer: Inform the consumer of the location of the gas shut-off valve.
EN 9