Table of Contents
Advertisement
ATTENTION!
Operating the appliance without food in the cooking
compartment may lead to overloading.
Do not switch on the microwave unless there is food
▶
inside. The only exception to this rule is when per-
forming a short cookware test.
WARNING ‒ Risk of scalding!
The accessible parts of the appliance become hot dur-
ing operation.
Never touch these hot parts.
▶
Keep children at a safe distance.
▶
Place the empty cookware in the cooking compart-
1.
ment.
Set the appliance to run for 30 seconds to 1 minute
2.
at maximum power.
Start the operation.
3.
Check the cookware several times:
4.
If the cookware remains cold or warm to the
‒
touch, it is suitable for microwave use.
If the cookware becomes hot or sparks are cre-
‒
ated, stop the cookware test. The cookware is
not microwave-safe.
11.2 Configuring the microwave settings
Notes
¡ Note the correct way to handle the microwave:
– → "Safety", Page 2
– → "Preventing material damage", Page 6
– → "Microwave power settings", Page 11
– → "Cookware and accessories with microwave",
Page 16
¡ To prevent condensation, the appliance automatic-
ally switches on a heating element at the maximum
microwave power settings of 600 watts and max.
The cooking compartment and the accessories be-
come hot. The cooking result is not affected by this.
You can switch off this drying function in the basic
settings.
→ "Basic settings", Page 20
WARNING ‒ Risk of burns!
At the highest settings in microwave only mode, the
drying function will automatically switch on an addi-
tional heating element to heat the cooking compart-
ment.
Never touch the inside surfaces of the cooking com-
▶
partment or the heating elements while they are hot.
Keep children at a safe distance.
▶
Press
.
1.
Press "Microwave".
2.
Press the button for the microwave power setting
3.
that you require.
Use the control ring to set the cooking time.
4.
Press
to start.
5.
a The microwave starts and the cooking time counts
down. The heating line does not appear.
a When the time has elapsed, a signal sounds. The
time shown in the display is zero.
When the cooking time has elapsed:
6.
To stop the signal early, press any touch field.
‒
If necessary, set a microwave power setting and
‒
a cooking time again.
When the food is ready, press
‒
appliance off.
If you have switched off the drying function for the
7.
microwave in the basic settings, dry the cooking
compartment.
→ "Drying", Page 23
Note: If you open the appliance door during operation,
the operation stops. When you close the appliance
door, you have to press
changed the basic setting, make sure that the mi-
crowave does not resume operation without food in-
side.
→ "Basic settings", Page 20
Changing the microwave power setting
If you change the microwave power setting, the set
cooking time set is retained.
Press
to pause operation.
1.
Press the button for the microwave power setting
2.
that you require.
Press
to continue operation.
3.
Changing the cooking time
After the start of the microwave operation, you can
change the cooking time directly.
Use the control ring to change the cooking time.
▶
a The change is applied immediately.
11.3 MicroCombi
To reduce the cooking time, you can use some types
of heating in combination with microwave mode.
Possible types of heating are:
¡ 4D hot air
¡ Top/bottom heating
¡ Circulated air grilling
¡ Grill, large area
¡ Grill, small area
Possible microwave power settings are:
¡ 90 watts
¡ 180 watts
¡ 360 watts
Setting MicroCombi
Note:
Note the correct way to handle the microwave:
¡ → "Safety", Page 2
¡ → "Preventing material damage", Page 6
¡ → "Microwave power settings", Page 11
¡ → "Cookware and accessories with microwave",
Page 16
1.
Press
.
Press "MicroCombi".
2.
Press the type of heating that you want to use.
3.
Press the button for the microwave power setting
4.
that you require.
Use the control ring to set the temperature.
5.
Microwave en
to switch the
to continue. If you have
17
Advertisement
Table of Contents
