Linear Acoustic AERO.one V3 User Manual page 46

Linear Acoustic AERO.one V3 User Guide
Multiband Limiters
Performs multiband limiting of the signals coming from the multiband compressor.
Multiband EQ
This is the section where each of the processing bands is summed and where overall fre-
quency response can be tailored.
B4:88, B5:92)
-How fast an input signal recovers from a gain change once that signal falls be-
low the set threshold.
• B1 - B5 AGC Thresh(old): -12.00dB - +12.00dB (default: 0.00dB all)
-The reference point for the attack and release parameters to act on the audio
signal present in that band.
• B1 - B5 Lim(it) Thresh(old): +12.00dB - 0.00dB (default: B1:+4.25dB,
B2:+4.25dB, B3:+6.50dB, B4:+9.00dB, B5:+9.00dB)
-The point above which limiting action takes place at an Infinity:1 ratio.
• B1 Soft Clip Thresh(old): +12.00dB - 0.00dB (default: +3.00dB)
• B2 Soft Clip Thresh(old): +12.00dB - 0.00dB (default: +6.00dB)
-The point above which band one (low bass) is very quickly limited, acting
more like a clipper without the artifacts. This helps maintain a "tight" bass
sound.
• B1 - B5 Out(put) Mix: -12dB - + 12dB (defaults: 0dB, all bands)
-Sets the mix level for each band summing all bands back together. These con-
trols are prior to the final look ahead limiter and increasing gain may cause
more final limiting (possibly more than desired)
Presets, Processing & Metadata
40