Table of Contents
Advertisement
Linear Acoustic AERO.one V3 User Guide
Chapter 2: Connections and Quick Setup
This chapter covers all required connections for the AERO.one.
2.1
Unpacking and Inspection
Before unpacking the unit, inspect the outer carton for shipping damage. If the carton
shows damage, inspect the unit in those areas. Please save the carefully designed shipping
carton and packing materials. In the unlikely event that the unit needs to be returned to the
factory, alternate cartons or packing materials may not be adequate and can cause damage
not covered by warranty.
The following essential items are provided with the unit:
•
Bag containing:
•
Quick-start sheet to get you up and running
•
IEC power cords (style matches country of order);
•
this manual, and a handy black pen.
•
Warranty information: Please fill out and return the warranty card to Linear Acoustic
to ensure your software and documentation are kept up to date.
2.2
Installation
AERO.one installation requires:
•
One standard rack space unit with ADEQUATE VENTILATION (the unit relies on
convection cooling from side-panel vents);
•
standard 75-Ohm BNC cables for digital signal connections;
To connect to digital equipment with 110-Ohm XLR connectors, use impedance-
matching transformers (available from Canare, Neutrik and other manufacturers).
•
Proper reference. The unit can be synchronized to AES Input 1, AES Input 4, SDI, or
Internal 48kHz. All inputs have SRCs but a master reference is required. Proper refer-
ence signal selection and application is imperative for an artifact-free installation.
Clicks or pops can usually be traced back to improper reference configuration.
7
Advertisement
Table of Contents
