Stiga CP1 534 Series Operator's Manual page 27

• Make sure that machine movements do not cause damage
or injuries.
When transporting the machine on a vehicle or trailer, always:
• Use an access ramp of suitable strength, width and length.
• Load the machine with the motor switched off and pushed by
an adequate number of people.
• Lower the cutting means assembly (par 5.6).
• Position it so that it cannot cause a hazard for anybody.
• Fasten firmly to the device of transport using ropes or chains
to prevent it from tipping over causing damage and fuel
leaks.
Do not transport machines that can be stored in
vertically in such an upright position.
10. MAINTENANCE TABLE
MACHINE
Check all fasteners ; Safety checks/check controls (including the Operator Presence
Control handlebar); Check the rear/lateral discharge guards; Check the grass catcher
bag and lateral discharge chute; Check the cutting means.
General cleaning and inspection; Checking for any damage to the machine.
If necessary, contact the authorised service centre.
Replacing the cutting means
ENGINE
Checking/topping up fuel level; Check/top-up engine oil
Air filter check and cleaning; Spark plug contacts check and cleaning;
Spark plug replacement; Charging the battery
* Refer to the engine manual. *** Operation to be performed at the first signs of any malfunction
*** The operation must be carried out by your Dealer or a Authorised Service Centre
11. PROBLEM IDENTIFICATION
If problems persist after having performed the above operations, contact your dealer.
PROBLEM
1. The engine Incorrect starting procedure
does not start,
No oil or fuel in the engine.
does not
Dirty spark plug or incorrect electrode
keep running,
gap.
operates
irregularly or Clogged air filter.
stops during
Carburation fault.
operation
The floating device may be blocked.
2. Engine flood- The manual start handgrip has been
ing. operated repeatedly with the starter
engaged.
The manual start handgrip has been
operated repeatedly with the spark plug
cap removed.
3. The cut grass The cutting means hit a foreign object.
is no longer
collected in
The inner part of the chassis is soiled.
the grass
catcher.
Intervention
PROBABLE CAUSE
Frequency
Before use
After each use
Before use
Follow the instructions (see chap. 6.3).
Check the oil and fuel levels (see chap. 7.2.1 / 7.2.2).
Check the spark plug (refer to the engine manual).
Clean and / or replace the filter (Refer to the engine manual).
Contact your Authorised Service Centre
Refer to the engine manual and contact an Authorised Service
Centre.
Refer to the engine manual.
Insert the spark plug cap and try to start the engine.
(Refer to the engine manual).
Stop the engine and remove the spark plug cap. Check for any
damage and contact an authorised service centre (section 7.3.1).
Clean the internal part of the chassis (par. 7.4.2).
EN - 7
Notes
par. 6.2.2
par. 7.4
- par. 7.3.1 ***
par. 6.1.1 / 7.2.1 * / 7.2.2 *
* * / par. 7.5 *
SOLUTION