Specifications - Makita HM0810 Instruction Manual

ENGLISH
1. Lock button
2. Switch trigger
3. Side grip
4. Bull point
5. Tool retainer
6. Red dot (Tool holder)

SPECIFICATIONS

Model
Blows per minute
Overall length
Net weight
Safety class
• Due to our continuing programme of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
.... Read instruction manual.
.............. DOUBLE INSULATION
Intended use
The tool is intended for chiselling work in concrete, brick,
stone and asphalt as well as for driving and compacting
with appropriate accessories.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
General Power Tool Safety
Warnings
WARNING! Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
4
Explanation of general view
7. Red dot (Tool retainer)
8. Commutator
9. Insulating tip
10. Carbon brush
11. Hex wrench
12. Rear cover
HM0810
2,900 min
410 mm
6.1 kg
Save all warnings and
END201-5
instructions for future reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
Work area safety
1. Keep work area clean and well lit. Cluttered or dark
2. Do not operate power tools in explosive
ENE045-1
3. Keep children and bystanders away while
ENF002-1
Electrical safety
4. Power tool plugs must match the outlet. Never
5. Avoid body contact with earthed or grounded
GEA005-3
6. Do not expose power tools to rain or wet
7. Do not abuse the cord. Never use the cord for
13. Screwdriver
14. Brush holder cap
15. Lock nut wrench
16. Crank cap
17. Hammer grease
-1
/II
areas invite accidents.
atmospheres, such as in the presence of
flammable liquids, gases or dust. Power tools
create sparks which may ignite the dust or fumes.
operating a power tool. Distractions can cause you
to lose control.
modify the plug in any way. Do not use any
adapter plugs with earthed (grounded) power
tools. Unmodified plugs and matching outlets will
reduce risk of electric shock.
surfaces such as pipes, radiators, ranges and
refrigerators. There is an increased risk of electric
shock if your body is earthed or grounded.
conditions. Water entering a power tool will increase
the risk of electric shock.
carrying, pulling or unplugging the power tool.
Keep cord away from heat, oil, sharp edges or
moving parts. Damaged or entangled cords increase
the risk of electric shock.
HM0810B
-1
2,900 min
433 mm
5.8 kg