Auto Meter 5336 Installation Instructions

2650-1339-00
INTRODUCTION
Thank you for your purchase of the Pit Road Speed device (PRS) from Auto Meter Products, Inc.
The following basic features are included on this product:
• Single precise user-configurable set point
• Quick-reacting, intensely-bright LED light
• Four configurable speed bands
• Quick capture via remote push button
Please read and follow the instructions below regarding the installation and operation of your PRS to receive maximum benefit and accuracy from this product.
Failure to follow the information below will void the product warranty and may result in damage to your vehicle, this product, and/or personal injury.
NOTE: This product features INTENSELY-BRIGHT LEDS! This feature is intended for maximum driver visibility during daytime operation and high glare situations.
Usage of this product at full brightness during nighttime or extremely dark settings may adversely affect driver's vision. Auto Meter strongly recommends that you
familiarize yourself with the dimming function of this product and that you do not operate the product at full brightness during dim or dark lighting conditions.
INSTALLATION
1. Disconnect the negative (-) battery cable.
2. Gauge can be mounted in a 2 1/16" dia. hole with the bracket supplied. Gauge can also be mounted in an Auto Meter Mounting Cup, Panel, or Auto Meter
Gauge Works Pod.
3. Tube version can be mounted on the dash or strapped to the steering column.
4. Wire the PRS as indicated. See schematic on following page for more info:
Red Wire: Connect to a fused and switched 12V positive source that is turned on and off with the ignition switch.
Black Wire: Connect to a good engine, chassis, or battery ground.
Green Wire: Connect to the negative terminal of a standard ignition coil, or to the "Tach Output" terminal on the Electronic Ignition Module. (See diagram)
Blue Wire:
(Optional) Connect to a Remote Capture Switch "Normally Open" contact (normally open, momentary closed).
QUICk SET OPTIONS:
Day/Night Dimming control: This product is extremely bright at the maximum setting for best visibility for drivers during high glare situations. Auto Meter
does not recommend operating this product at full brightness during extremely dark or night time driving conditions. To adjust this product from the daytime or
"High" brightness setting to the nighttime or "Low" brightness setting do the following:
• Press the MODE (+) button. The light will illuminate at the new brightness level.
RPM SET POINT QUICk SET - To change your PRS Set Point Setting quickly, use one of the following methods:
1. ENTER Button method:
When the car is in the desired gear and moving at the desired speed, press the ENTER button. You will see the Shift Light turn on Green, indicating
the new setting was captured.
2. Remote Capture Switch method:
This method requires the Blue wire be attached to a "Normally Open" switch (normally open, momentary closed) mounted in a convenient location.
When the car is in the desired gear and moving at the desired speed, press and release switch button. You will see the Shift Light turn on Green,
indicating the new setting was captured. (Note: The RPM is captured the moment the switch is released)
INSTALLATION INSTRUCTIONS
Pit Road Speed Gauge and Tube
• Progressive color change for speed bands
• User selectable dimming function
• Set point is based on engine RPM