Setting Values; Setting Values Standard Appliance - ubbink Ubiflux Vigor W400 Installation Regulations

13 Setting values

13.1 Setting values standard appliance

The below setting values are for a Ubiflux Vigor W400-appliance without Plus pcb.
Step
Description
No
1 Flow rate
1.1 Air flow rate setting 0
1.2 Air flow rate setting 1
1.3 Air flow rate setting 2
1.4 Air flow rate setting 3
1.5 Imbalance permissible
1.6 Imbalance (Open fireplace)
1.7 Offset supply
1.8 Offset exhaust
1:19 Default fan setting
2 Bypass
2.1 Mode Bypass
2.2 Bypass temperature "from
dwelling"
2.3 Bypass temperature "from
outside"
2.4 Bypass hysteresis
2.5 Mode Bypass boost
2.6 Fan setting selection Bypass
boost
3 Frost protection
3.1 Frost temperature
3.2 Minimum intake temperature
4 Filter message
Factory settings Setting range
50 m³/h 0 or adjustable between 50 m³/h and 400
m³/h (never higher than step no. 1.2)
100 m³/h Adjustable between 50 m³/h and 400
m³/h (not higher than step no. 1.3 or
lower than step no. 1.1)
200 m³/h Adjustable between 50 m³/h and 400
m³/h (not higher than step no. 1.4 or
lower than step no. 1.2)
300 m³/h Adjustable between 50 m³/h and 400
m³/h (not lower than step no. 1.3)
Yes Yes / No
0% 0% / +20%
0% -15% / +15% fan setting
0% -15% / +15% fan setting
1 0 or 1
Automatic - Automatic
- Bypass closed
- Bypass open
24 °C 15 °C / 35 °C
10°C 7 °C / 15 °C
2 °C 0 °C / 5 °C
Off On / Off
3 0 / 3
0 °C -1,5 °C /1,5 °C
10 °C 7 °C /22 °C
Ubiflux Vigor W400 615912-D
Comment
Value calculated
back to set flow
rate, see screen
Ubbink / 51