Battery Backup Function - Dialight Vigilant Operation & Installation Instructions

6. Close battery cover by tightening six 10-32 captive screws as shown to 28-30 in-lbs.
NOTE: When closing, be sure no wires interfere with closure to avoid risk of pinching.

Battery Backup Function

Battery Backup Indicator Light Functions
LED Indicator Status
Green ON and blinks every 10s
Red ON and blinks every 5s
Red LED Blinks every 2s
RED LED Blinks every 1s
Green LED Blinks every 2s
Green LED blinks every 1s
*Function Test – Tests for the basic functionality of battery and light output connections
*Duration/Commissioning Test – Tests for full duration of light output in battery backup mode.
Technical Data
Area Light Battery Backup
Nominal AC Supply Voltage
120-277V AC, 50-60Hz, Single Phase
Power Consumption
[Lumens]
9000
7000 (Wide Optic)
7000
6000
4000
3000
Power Factor(AC only)
ATHD(AC only) <10% @120VAC
<10% @230/240VAC
<12% @277VAC
Temperature
-4°F to +131°F [-20°C to +55°C]
Page 5
Area Light with Battery Backup UL1598/A / UL844 / UL924
Technical Data
Area Light Battery Backup (cont.)
Housing Material
A360 Die Cast Aluminum
Finish
[W] Powder Coat
71 Gray, RAL 7040
69
57 Lens
45 Polycarbonate or glass
35
29 Dimensions
Conduit Mount option
>0.95 10.7 x 12.2 x 8.1 in.
[271 x 311 x 205 mm]
All other mounting options
Size varies by mount type
Status/Mode
System OK/AC OK
Battery not detected/Faulty, Check connections/Replace Battery
Light Output Fault. Check wiring connections
Multiple faults
Performing Function Test*
Performing Duration Test/Commissioning Test*
Dialight, 1501 Route 34 South, Farmingdale, NJ, USA 07727
Tel: 732 919 3119
9100HZC280501 REV B
Fax: 732 751 5778 www.dialight.com