Lighting Inspection Test for F and C structure types ..............30 Lighting Inspection Tests for G and B structure types ..............31 Revision History ..........................31 1501 Route 34 South, Farmingdale, NJ 07727 Tel: (732) 919-3119 Fax: (732) 751-5778 www.dialight.com Page 2 of 31...
Lightning and RF immunity at each section, but for it to be effective proper ground connection techniques must be used. Warranty Please visit www.dialight.com/resources/warranties for the latest warranty policy. 1501 Route 34 South, Farmingdale, NJ 07727 Tel: (732) 919-3119 Fax: (732) 751-5778 www.dialight.com Page 3 of 31...
NOTE: Calibration can be done once all lights are connected or done as levels are installed. NOTE: Only calibrated side lights will be monitored. 1501 Route 34 South, Farmingdale, NJ 07727 Tel: (732) 919-3119 Fax: (732) 751-5778 www.dialight.com Page 4 of 31...
Each calibration port has been designed to accurately power and monitor up to 4 L810’s simultaneously. If no Side lights are connected or wired in-correctly all corresponding LED’s will turn off. If for some un-foreseen reason additional L810’s are required contact www.Dialight.com. 1501 Route 34 South, Farmingdale, NJ 07727 Tel: (732) 919-3119 Fax: (732) 751-5778 www.dialight.com...
On the left side of the display will be the “UP” and “DWN” buttons. On the right side of the display will be the “ENTR” and “CLR” buttons. 1501 Route 34 South, Farmingdale, NJ 07727 Tel: (732) 919-3119 Fax: (732) 751-5778 www.dialight.com Page 6 of 31...
Check the RS485 communications cable for proper wiring. Verify connection at the Base Controller, junction boxes, surge boards, and power supplies. Initial 15 Flashes In Process 1501 Route 34 South, Farmingdale, NJ 07727 Tel: (732) 919-3119 Fax: (732) 751-5778 www.dialight.com Page 7 of 31...
AL1 and S7 will illuminate RED indicating the Base Controller recorded more/less than the selected total Beacons. Number of BC = 9 u/d =chg, enter=done 1501 Route 34 South, Farmingdale, NJ 07727 Tel: (732) 919-3119 Fax: (732) 751-5778 www.dialight.com Page 8 of 31...
Page 9
An AOL can be added or disabled at any time during the operation of the system. The AOL must be approved by Dialight if added after initial system installation for compatibility. The Base Controller can accommodate up to three AOL units.
Page 10
Trans PEC Alrm = NO u/d=chg, enter=done u/d=chg, enter=done Use “UP” and “DWN” buttons to change from “NO” to “YES”, and then press “ENTR.” 1501 Route 34 South, Farmingdale, NJ 07727 Tel: (732) 919-3119 Fax: (732) 751-5778 www.dialight.com Page 10 of 31...
Page 11
If no sidelights are installed within the system, the value will be set to Disable. L810 MODE= Steady u/d =chg, enter=done 1501 Route 34 South, Farmingdale, NJ 07727 Tel: (732) 919-3119 Fax: (732) 751-5778 www.dialight.com Page 11 of 31...
Page 12
This screen allows the setup of the flash rate of the sidelights. This will be set to 30 to match the flash rate of the high intensity flashheads during Night mode. Flash per min= 30 u/d =chg, enter=done 1501 Route 34 South, Farmingdale, NJ 07727 Tel: (732) 919-3119 Fax: (732) 751-5778 www.dialight.com Page 12 of 31...
Page 13
After the reset, the Base Controller LCD will reboot and initialize with the new settings. Once completed, the Home Screen will appear. BC= 12, AL=1, SL=4, EX=N ‘enter’ to change Example Home Screen 1501 Route 34 South, Farmingdale, NJ 07727 Tel: (732) 919-3119 Fax: (732) 751-5778 www.dialight.com Page 13 of 31...
System must be in Day mode with the photocell before starting the test. Press “ENTR” to initiate Lighting Inspection. Manual LI TEST “enter” to Test 1501 Route 34 South, Farmingdale, NJ 07727 Tel: (732) 919-3119 Fax: (732) 751-5778 www.dialight.com Page 16 of 31...
Base Controller will not affect the date/time stamp. The time will not change automatically for Daylight Savings. MMM, DD,YY “Time” MMM, DD, YY “Time” ‘Enter’ to set Clock UD=Chg E=NEXT C=EXIT 1501 Route 34 South, Farmingdale, NJ 07727 Tel: (732) 919-3119 Fax: (732) 751-5778 www.dialight.com Page 17 of 31...
LCD must be programmed for additional AOL(s). Tower Style: X Beacon, AOL, RED, FAA Type G System with No Sidelights or AOL Tower Style: G Beacon, , RED, 1501 Route 34 South, Farmingdale, NJ 07727 Tel: (732) 919-3119 Fax: (732) 751-5778 www.dialight.com Page 18 of 31...
Forces Twilight Forces White at night Twilight Mode Forces Night White Forces White at Night White Night Mode Forces Day White Stays RED/IR 1501 Route 34 South, Farmingdale, NJ 07727 Tel: (732) 919-3119 Fax: (732) 751-5778 www.dialight.com Page 19 of 31...
If during initial power up an address is blank, the base controller does not recognize any power supplies/flashheads. Check all RS485 connections and power supply addresses. 1501 Route 34 South, Farmingdale, NJ 07727 Tel: (732) 919-3119 Fax: (732) 751-5778 www.dialight.com Page 20 of 31...
This reset will go through the full warm up and the initial 15 flash countdown menu. 1501 Route 34 South, Farmingdale, NJ 07727 Tel: (732) 919-3119 Fax: (732) 751-5778 www.dialight.com Page 21 of 31...
6. All external cord grips and conduit connected to the enclosure are tightened to prevent water egress. 7. Upon validation of the working power supply the enclosure has to closed and four clamps closed. 1501 Route 34 South, Farmingdale, NJ 07727 Tel: (732) 919-3119 Fax: (732) 751-5778 www.dialight.com Page 22 of 31...
Number, Highest Error Active or 18 max Code was last Error. Modules with Errors Cleared Status Displayed as 1,2,3 Act or Clr displayed 1501 Route 34 South, Farmingdale, NJ 07727 Tel: (732) 919-3119 Fax: (732) 751-5778 www.dialight.com Page 23 of 31...
Page 24
The system has been in Day Alarm Day to Twi the transition from Day to mode for more than 18 Alarm 5 twilight hours 1501 Route 34 South, Farmingdale, NJ 07727 Tel: (732) 919-3119 Fax: (732) 751-5778 www.dialight.com Page 24 of 31...
Page 25
Power Supply Alarm not respond to poll, or Alarm 1 Check J7 –J9 (RS485) X COMM BC response was corrupted Faulty module 1501 Route 34 South, Farmingdale, NJ 07727 Tel: (732) 919-3119 Fax: (732) 751-5778 www.dialight.com Page 25 of 31...
Page 26
External sync pulse from Event No Ext Sync external device (eg: GPS) row will cause external device lost has been lost Alarm 2 1501 Route 34 South, Farmingdale, NJ 07727 Tel: (732) 919-3119 Fax: (732) 751-5778 www.dialight.com Page 26 of 31...
Page 27
Event SW to TWILIGHT Changed mode to Twilight mode Photocell changed to night Event SW to NITE Changed mode to night mode 1501 Route 34 South, Farmingdale, NJ 07727 Tel: (732) 919-3119 Fax: (732) 751-5778 www.dialight.com Page 27 of 31...
NOTE: If the system had active alarms before the test then these alarms will remain on the dry contacts but the alarm log will not display them again. 1501 Route 34 South, Farmingdale, NJ 07727 Tel: (732) 919-3119 Fax: (732) 751-5778 www.dialight.com Page 28 of 31...
Page 29
NOTE: If the QLI manual test is not completed due to prompts not being followed, tests will time out after 5 minutes and display: Manual LI TEST LIT NOT DONE 1501 Route 34 South, Farmingdale, NJ 07727 Tel: (732) 919-3119 Fax: (732) 751-5778 www.dialight.com Page 29 of 31...