Removal Of Punch Module - Canon Professional Puncher-A1 Service Manual

• Using a flat-head screwdriver, turn the adjustment screw clockwise or counter-
clockwise to move the die set position cradle.
NOTE: Seven full turns of the adjustment screw result in a ¼" change in the
punched hole position.
• Before tightening the lock-down screw, tilt or bias the assembly towards the
bottom of the machine and tighten the lock-down screw. This will ensure positive
engagement between the locking lever and the die set.
• Run a test sample of punched paper and recheck paper alignment. Re-adjust if
necessary.
4.3

REMOVAL OF PUNCH MODULE

1. Examine the Drive Belts. Note the consistency in tightness of the belts. They
should all have approximately ¼" of deflection; remove the four drive belts items
1, 2, 3, 4.
Disconnect the Sensor Wire Connection
TILT TO BOTTOM
OF M/C
Get other manuals https://www.bkmanuals.com
TURN
CLOCKWISE
TIGHTEN
SCREW
13