Tools Required For Assembly; Before You Start - Sahara S350 Manual

Fixings Supplied
Ref Description
M6x12mm
A
Hex Bolt
M6x80mm
B
Bolt
C
Spacer
NOTE: Fixings not shown to actual size.

Tools Required For Assembly

• Philips Head Screwdriver (provided)
• Ball head hexagon wrench (provided)
• 22mm Spanner (provided)

Before You Start

• Check the contents of the box and make sure you have all the parts and fittings listed. If not,
contact our Helpline 00 353 1 2873797 and we will be able to help you.
• When you are ready to start, make sure that you have plenty of space and a clean dry area
for assembly.
• Before cooking on this barbecue, turn the barbecue on at the medium to high temperature
and burn for 30 minutes to allow curing of vapourising bars and to burn off cleaning residue
materials.
Assembly
• Please lay out all nuts and bolts and check lengths before assembly. It is recommended that
the carton is cut open and spread out on the floor and used as a protective surface during
assembly. Refer to the assembly diagrams as necessary.
• Important - while every precaution has been made in the manufacture of this product, care
must be taken during assembly in case sharp edges are present.
• Remove all transit packaged parts from the inside of the grill body before assembling.
Important - follow gas leak test advice before use. Ensure all connections are tight and secure.
• This product is for OUTDOOR USE ONLY.
• NEVER use indoors, in an enclosed area or below ground level.
• This barbecue is intended for use with LPG bottled gas only. (A regulator of 37mbar for Propane
gas.)
• NEVER use an adjustable regulator with this barbecue.
Page 4
Illustration Qty Ref Description
M4x10mm
16 D
Bolt
4
4
Illustration Qty
12