Square Portable Solar Light
Installation instructions
Warnings & Cautions
•
Do not install in areas that are exposed to continual running water or prone to flooding.
•
Ensure that the mounting surface is both flat and stable.
•
Any broken or damaged parts should be replaced as soon as possible.
•
JCC will not accept responsibility for claims arising from sub-standard installations
•
These products are suitable for indoor and outdoor use.
•
This product is battery powered and they are charged via the solar panel, it can also be charged
using a 5VDC mains adapter plug and USB charging lead supplied.
•
Only the supplied mains adapter plug and USB lead should be used for charging
•
The batteries in this product are rechargeable and must only be replaced by a competant person.
Specifications
Colour temp: 3000K Ra: 84 (Class II
Product
Wattage
Lumens
code
JC17065
3W
238
1. Prior to use, ensure that the product is fully charged
2. Connect the micro USB lead to the charging port by removing the
silicone protective cover( Fig.1). Using the supplied Mains Adapter,
connect the USB lead to the mains supply(Fig.2).
3. When the mains supply is connected the Touch Switch(Fig.3) will turn
red. Once fully charged, the Touch Switch will turn green.
(Note: the Batteries have built in over-charge protection)
4. Operation of Touch Button:
1. Single Touch: on or off
2. Press/Hold when on: Light increases gradually
(release button when light level is achieved.)
3. When on, press for more than 4 secs
(100% light output)
5. When on, single Touch fades light to off
General Maintenance Requirements
JCC Lighting Products recommends that the this product is cleaned with warm water and dried with a chamois leather of absorbent dry cloth.
Weathering, environmental pollution and birddroppings should be cleaned off with a non-abrasive cleaner. This is to ensure that the solar panel is
fully effective in charging the batteries, and to preserve the finish of this product.
You can help protect the environment. Please remember to respect the local regulations: hand in the non-working electrical equipment to an
appropriate waste disposal centre. The packaging material is recyclable. Dispose of the packaging in an environmentally friendly manner and make
it available for the recyclable material collection service.
Important warranty information
This product is supported by a 2-year standard warranty which will extend to 3 years if registered within the first year of purchase.
(2 year on batteries). Please register at jcc.co.uk/warranty - Terms and conditions apply.
The installer will be asked to provide the following information, which is detailed on a label attached to the luminaire's chassis:
Product Code/Date Code.
JCC Lighting Products Ltd. Innovation Centre, Beeding Close, Southern Cross Trading Estate, Bognor Regis, West Sussex, PO22 9TS, United Kingdom
Technical Support: +44(0)1243 838986 Customer Services: +44(0)1243 838999
INSTALLATION
Mains USB
Solar
Charging
Charging
Time
Time
6-7 hrs
16-17 hrs
Fig.1.
BS EN ISO9001 - 2015 - Registered Firm Certificate No. GB 1552
Plug Adapter, Class III
Solar light)
Maximum
run time
9 hrs
Mains USB Adapter:
100-240V~ 50/60Hz
5V
1A
Fig.2.
a
company
LED
LED
Non-replaceable light source
ENGLISH
Micro USB Lead:
1.2 metres
Fig.3.
jcc
IP54
RoHS
.co.uk
Compliant
V1_August_2021_RS
Need help?
Do you have a question about the JCC JC17065 and is the answer not in the manual?
Questions and answers