http://waterheatertimer.org/How-to-wire-Cooper-277-pilot-light-switch.html
PK-93609-10-00-0A
WARNINGS AND CAUTIONS:
• To be installed and/or used in accordance with appropriate electrical codes and regulations.
• To avoid fi re, shock or death, TURN OFF POWER at circuit breaker or fuse. Test that
power is off before wiring.
• Use these devices only with copper or copper clad wire. With aluminum wire use only
devices marked CO/ALR or CU/AL.
• NOTE: The following diagrams apply to both Standard Style and Decora Style
Combination Devices.
Tools needed to install Switch:
• Slotted, Phillips, or Robertson Screwdriver
• Wire Cutters
INSTALLING SWITCH:
NOTE: Use check boxes
WARNING:
Step 1
TURN OFF POWER at circuit breaker or
fuse and test that power is off before wiring!
Single Pole Switch with Pilot Light
Standard Style Cat. No. 5226
Decora Style Cat. No. 5626
Switch Rated: 15A-120VAC – Pilot Light Rated:
INSTALLATION INSTRUCTIONS
Identify Wall Box Wiring:
Step 2
To install this combination switch, the
following wires must be present inside
wall box.
when Steps are completed.
To avoid fi re, shock, or death;
1
/
W-125VAC
4
Standard Style Switch
Cat. No. 5226
Single Pole
Pilot Light
NOTE: Ground connections may differ in your
application. Ensure the device is properly
grounded to system. If the wiring in the
wall box does not resemble any of these
confi gurations, consult a qualifi ed electrician.
Prepare Wires:
Step 3
Remove 5/8" (1.6 cm) of insulation from
each wire in the wall box.
SINGLE LINE HOT
(Common Feed)
1. Line (Hot-System)
2. Neutral
3. Ground
4. Load - Single Pole
Decora Style Switch
Cat. No. 5626
Single Pole
Pilot Light
Strip 5/8"
(1.6 cm)
5/8"
(1.6 cm)
Strip Gage
Need help?
Do you have a question about the Decora Standard 5226 and is the answer not in the manual?
Questions and answers