During Use; Service And Maintenance; Cleaning The Display - Beijer Electronics X2 base 15 v2 HP Hardware And Installation Manual

Hide thumbs Also See for X2 base 15 v2 HP:

Table of Contents

• Separate the high voltage, signal, and supply cables.

• Make sure that the voltage and polarity of the power source is correct before connecting the HMI

panel to the power outlet.

• Peripheral equipment must be appropriate for the application and location.

1.6. During Use

• Keep the HMI panel clean.

• Emergency stop and other safety functions may not be controlled from the HMI panel.

• Do not use excessive force or sharp objects when operating the touch screen.

• Only qualified personnel should carry out repairs.

• The agreed warranty applies.

• Before carrying out any cleaning or maintenance operations, disconnect the equipment from the

electrical supply.

• Clean the display and surrounding front cover with a soft cloth and mild detergent.

• The battery must be replaced by an authorized Beijer Electronics service center.

We recommend using a dry, clean cloth to wipe off dust regularly. Use alcohol or ammonia-based

cleaning agent for cleaning only when necessary. When other solvents or cleaning agents are used,

be sure to follow manufacturers' instructions. The agent should be applied to a clean cloth and

should not be sprayed directly onto the panel surface. After cleaning the agent should be removed.

Ammonia-based glass cleaners (typically 5-10% ammonia) or 75% alcohol can be used to clean the

surface of PCAP and resistive touch panels. When you clean the surface of your touch panel, please

follow these steps:

Apply cleaning agent (alcohol, bleach, or glass cleaner) to a clean cloth.

Make sure the cloth is well saturated.

Wipe the touch panel surface in a "Z" motion (see illustration below).

Dry the panel thoroughly with a dry cloth, removing as much of the cleaning solution as possible.

Do not mix bleach and ammonia because this will produce a dangerous chemical reaction.

Please do not spray cleaning solution directly onto the touch panel surface.

Beijer Electronics, MAEN333

Safety Precautions

2023-09

Table of Contents

Do you have a question about the X2 base 15 v2 HP and is the answer not in the manual?