Troubleshooting - Xxxlutz IMB1000-GS Manual

Ice Cube Maker
• Thoroughly wipe down the device
(inside and outside) and the ice cube
container and the ice cube scoop with
a dry cloth.
• Store the device in a dry, clean, frost-
free place that is protected from di-
rect sunlight and cannot be accessed
by children or animals.
Cleaning Programme
The device has a cleaning programme
which should be used at least once or
twice a month, and more frequently if the
device is used regularly.
1. Drain any remaining water (see previ-
ous section).
2. Soak a cloth in a water/vinegar solu-
tion and use it to wipe the inside of
the device.
3. Fill the water tank (6) with fresh water
(see the "Preparation" chapter).
4. Plug the connecting cable into a plug
socket that is easily accessible. The
symbol for the set ice cube size (10 or
11) lights up and the
flashes.
5. Press the SELECT button (15) to select
the cleaning programme
6. Start the cleaning programme by
pressing the ON / OFF button (16).
The symbol is lit constantly. The
device pumps the water through the
device for approx. 6 minutes and then
switches to stand-by mode.
7. Use the device in the usual way or
prepare it for storage (see previous
section).

TROUBLESHOOTING

If the device does not work properly,
check whether you are able to rectify the
problem yourself. If the problem cannot
be solved with the steps that are listed,
contact the customer service department.
The device does not work.
The mains plug is not inserted in the plug
socket correctly.
► Correct the fit of the mains plug.
The plug socket is defective.
► Try another plug socket.
There is no mains voltage.
► Check the fuse of the mains connec-
The device was not started.
► Press the ON / OFF button (16) to
symbol (9)
The ice cube container (7) is full. /
The
► Empty the ice cube container. The
(14).
The water tank (6) is empty. / The
► Fill the water tank and restart the
The fuse in the fuse box is triggered.
Too many devices are connected to the
same circuit.
► Reduce the number of devices in the
Do not attempt to repair an elec-
trical device yourself!
tion.
start the production of the ice cubes
or the cleaning programme.
symbol (12) lights up.
device carries on working automati-
cally.
symbol (13) lights up.
device by pressing the ON / OFF
button (16).
circuit.
EN
17