Use; Cleaning And Storage - Xxxlutz IMB1000-GS Manual

EN

USE

Please Note!
■
Only connect the device to a plug
socket that is properly installed. The
plug socket must also be readily
accessible after connection so that the
connection to the mains can quickly
be isolated. The mains voltage must
match the technical data of the device.
■
Lay the connecting cable so that it is
not squashed, bent or laid over sharp
edges and does not come into con-
tact with hot surfaces.
IMPORTANT! The cooling system of the
device is operated by a compressor (3).
It is normal for the compressor and the
cooling liquid in the refrigerant circuit to
make noises. The noises are louder when
you start using the device; they reduce as
you use the device more.
1. Completely unwind the connecting ca-
ble and plug it into a plug socket that
is easily accessible. The symbol for the
set ice cube size (10 or 11) lights up
and the
2. If necessary, change the ice cube size
by pressing the SELECT button (15).
3. Start making the ice cubes by pressing
the ON / OFF button (16).
The symbol is lit constantly.
The device initially pumps the water
through the cooling rods once in or-
der to cool down the water and then
starts making the ice cubes.
The device keeps operating until
○ the ice cube container (7) is full
(symbol
○ the water tank (6) is empty
(symbol
○ the production process is stopped
by pressing the ON / OFF button.
Once the ice cube container is emp-
tied, the
16
symbol (9) flashes.
(12) lights up);
(13) lights up);
symbol goes out and
the device automatically starts the
production process again.
After the water tank has been refilled,
the symbol goes out.
The production process needs to be
restarted by pressing the ON / OFF
button.
4. If the device is no longer going to be
used, pull the mains plug out of the
plug socket.
Drain any remaining water from the
device after every use (see the "Cleaning
and Storage" chapter).

CLEANING AND STORAGE

Please Note!
■
Allow the device to warm up to room
temperature before it is cleaned.
■
Do not use any sharp or abrasive
cleaning agents or cleaning pads to
clean the device. These may damage
the surfaces.
• Make sure that the device is not con-
nected to the mains power.
• Drain the rest of the water from the
device:
○ Pull the device over the edge of
the surface it is resting on until it is
protruding out by approx. 6 cm.
○ Hold a vessel with a sufficient ca-
pacity below the protruding device
and pull out the drain plug (5) on
the bottom of the device.
○ Allow all of the water to drain out.
○ Insert the drain plug all the way
back in the device.
• Clean the ice cube container (7) with
warm water and a little detergent if
necessary.
• If necessary, wipe down the housing
with a damp cloth. If there is heavy
soiling, use a little detergent if nec-
essary.