Replacement Bulbs; Electrical System; Fuses - GMC Equinox 2010 Owner's Manual

Hide thumbs Also See for Equinox 2010:
Table of Contents

Advertisement

6. Push the replacement bulb
straight into the bulb socket
and turn the bulb socket
clockwise to install into lamp
assembly.
7. Turn the lamp assembly into the
liftgate engaging the clip side
first.
8. Push on the lamp side opposite
the clip until the lamp assembly
snaps into place.

Replacement Bulbs

Exterior Lamp
Back-Up Lamp
Fog Lamp Front
Headlamp
High Beam
Headlamp
Low Beam
License Plate Lamp
Parking Lamp/Turn
Signal Front
Sidemarker Front
and Rear
Taillamp/Turn Signal
Lamp/Stop Lamp
For replacement bulbs not listed
here, contact your dealer/retailer.

Electrical System

Bulb

Fuses

Number
921
The wiring circuits in the vehicle are
protected from short circuits by
H11
fuses. This greatly reduces the
chance of damage caused by
HB3
electrical problems.
Look at the silver-colored band
H11
inside the fuse. If the band is broken
or melted, replace the fuse. Be sure
W5WLL
to replace a bad fuse with a new
one of the identical size and rating.
T20
There are two fuse blocks in the
vehicle: one in the engine
194
compartment and one in the
instrument panel.
3157K
There is a fuse puller located in the
engine compartment fuse block.
See Engine Compartment Fuse
Block on page 9 38. It can be used
to easily remove fuses from the fuse
block.
Vehicle Care
9-37

Advertisement

Table of Contents
loading

Table of Contents