Aqualisa Quartz QZD.A1.BR.20 Installation Manual page 13

8
Place the paper template on the wall in the desired location
for the controller and mark all fixing points and the data cable
entry point. Remove the template and drill a Ø16mm hole at the
appropriate position for the data cable.
!
Ensure the data cable is the correct way round as both ends differ in type of connection used
(transparent connector to the Quartz Smart Valve™ or diverter).
•
Data cables must be protected by suitable sheathing or conduit in the event of servicing and
maintenance. Failure to install this way may invalidate the warranty.
Care should be taken to ensure the mounting holes do not pierce the data cable conduit.
If installing this Quartz
purchase a concealed retro-fit wall plate to cover the existing hole in the tiling.
The cavity in the wall should be plugged using a suitable material for the wall plate to be
secured to. Contact our Customer Service Department to purchase product code:
QZD.B3.RWP.14 – Concealed retro-fit wall plate.
9
Drill and prepare the four wall fixings for the controller using the fixings provided, (if suitable).
10
Feed the controller connection end of the data cable through the
centre hole in the mounting plate. Run a bead of silicone sealant
in the mastic groove on the back of the mounting plate and press
into position on the finished wall surface. Ensure the data cable
is held securely by the narrow middle slot of the mounting plate
and fix to the wall using the brass screws provided.
11
Lining up the key way, push the data cable plug into the back
of the controller, ensuring both rubber skirts are recessed into
the connection (see diagram below), using a blunt flat bladed
screwdriver or similar tool if required. To make a water tight
fitting, ensure the rubber seal is no longer visible.
Slide the controller onto the mounting plate.
™
product as a replacement product, it may be necessary to
Quartz™ Installation Guide 13