Add Fuel - PowerTec PT3300Ei Operating Instructions Manual

3300w digital inverter generator
Table of Contents

Advertisement

PT3300Ei
ASSEMBLY
Add Engine Oil Cont'd.
Degrees Celsiusº(Outside)
Full Synthetic 5W-30
Degrees Fahrenheitº(Outside)
NOTE
Weather will affect engine oil and engine
performance. Change the type of engine oil used
based on weather conditions to suit the engine
needs.
NOTE
Synthetic oil may be used after the 5 hour initial
break-in period. Using synthetic oil does not
increase the recommended oil change interval.
3300W DIGITAL
INVERTER GENERATOR
www.powertec.net.nz

Add Fuel

1.
Use clean, fresh, regular unleaded petrol.
2.
DO NOT mix oil with fuel.
3.
Clean the area around the fuel cap.
4.
Remove the fuel cap.
5.
Slowly add fuel to the tank. DO NOT OVERFILL.
Fuel can expand after filling. A minimum of
1/4 in. (6.4 mm) of space left in the tank is required
for fuel expansion, more than 1/4 in. (6.4 mm) is
recommended. Fuel can be forced out of the tank as a
result of expansion if it is overfilled, and can affect the
stable running condition of the product. When filling
the tank, it is recommended to leave enough space for
the fuel to expand.
6.
Screw on the fuel cap and wipe away any spilled
fuel.
CAUTION
Use regular unleaded petrol with a minimum
octane rating of 85.
Do not mix oil and gasoline.
Fill tank to approximately 1/4 in. (6.4 mm) below
the top of the tank to allow for fuel expansion.
DO NOT pump gas directly into the generator at the
gas station. Use an approved container to transfer
the fuel to the generator.
DO NOT fill fuel tank indoors.
DO NOT fill fuel tank when the engine is running or hot.
DO NOT overfill the fuel tank.
DO NOT light cigarettes or smoke when filling the
fuel tank.
WARNING
Pouring fuel too fast through the fuel screen may
result in blow back of fuel at the operator while filling.
9.

Advertisement

Table of Contents
loading

Table of Contents