Troubleshooting; Generator Specifications - PowerTec PT3300Ei Operating Instructions Manual

TROUBLESHOOTING

Problem
Generator will not start
Generator will not start;
Generator starts but runs roughly
Generator shuts down during operation
Generator cannot supply enough power or
overheating
No AC output
Repeated circuit breaker tripping

GENERATOR SPECIFICATIONS

Model
Engine model
Displacement
Type
Running watts
Starting watts
Phase
Frequency
Voltage
Rater Current
Fuel Capacity
22.
Cause
No fuel
Faulty spark plug
Unit loaded during start up
Low oil level
Choke in the wrong position
Spark plug wire loose
Out of fuel
Low oil level
Generator is overloaded
Insufficient ventilation
Cable not properly connected
Connected device is defective
Circuit breaker is open
Loose wiring
Other
Overload
Faulty cords or device
PT3300Ei
PD230
208cc
4-Stroke OHV
3000
3300
Single
50Hz
230V
13 A
14 L
www.powertec.net.nz
PT3300Ei
3300W DIGITAL
INVERTER GENERATOR
Solution
Add fuel
Replace spark plug
Remove load from unit
Fill crankcase to the proper level
Place generator on a flat, level surface
Adjust choke
Attach wire to spark plug
Fill fuel tank
Fill crankcase to the proper level. Place
generator on a flat, level surface
Review load and adjust. See "Power
Management"
Check for air restriction. Move to a well
ventilated area
Check all connections
Replace defective device
Reset circuit breaker
Inspect and tighten wiring connections
Contact the help line
Review load and adjust. See "Power
Management"
Check for damaged, bare or frayed wires.
Replace defective device