Table of Contents
Advertisement
PT3300Ei
MAINTENANCE AND STORAGE
Generator Maintenance
Make certain that the generator is kept clean and stored
properly. Only operate the unit on a flat, level surface in
a clean, dry operating environment. DO NOT expose the
unit to extreme conditions, excessive dust, dirt, moisture
or corrosive vapors.
Cleaning
CAUTION
DO NOT spray engine with water.
Water can enter the generator through the cooling
slots and damage the generator windings. It can
also contaminate the fuel system.
Use a damp cloth to clean exterior surfaces of the generator.
Use a soft bristle brush to remove dirt and oil.
Use an air compressor (25 PSI) to clear dirt and debris
from the generator.
Inspect all air vents and cooling slots to ensure that they
are clean and unobstructed.
Storage
DANGER
Gasoline, gasoline vapors and liquid petroleum gas
(LPG/propane) are highly flammable and extremely
explosive.
Fire or explosion can cause severe burns or death.
Only fill or drain fuel outdoors in a well-ventilated
area. Do not pump gasoline directly into the
generator. Use an approved container to transfer the
fuel to the generator. Never use a fuel container,
hose, cylinder or any other fuel related item that
is damaged or appears damaged. Do not overfill
the fuel tank. Always keep fuel away from sparks,
open flames, pilot lights, heat and other sources of
ignition. Do not light or smoke cigarettes.
Short Term Storage (up to 1 year)
Petrol in the fuel tank has a maximum shelf life of up
to 1 year with the addition of properly formulated fuel
stabilizers and if stored in a cool, dry place. Petrol
in the carburetor, however, WILL gum up and clog the
carburetor if it isn't used or drained within 2 weeks.
3300W DIGITAL
INVERTER GENERATOR
www.powertec.net.nz
Short Term Storage Cont'd.
1. Be sure all appliances are disconnected from the
generator.
2. Add a properly formulated fuel stabilizer to the tank
(2-3 times manufacturer's recommended amount).
3. Run the generator for 10 minutes so the treated fuel
cycles through the fuel system and carburetor.
4. With the generator running, turn the fuel valve to the
"OFF" position and let the generator run until fuel
starvation has stopped the engine. This usually takes
a few minutes.
5. Turn engine switch to the "OFF" position.
6. Allow generator to cool completely before continuing.
7. Optional: to ensure fuel is completely drained from
the carburetor, use the drain bolt on the carburetor
to empty any excess gasoline into an appropriate
container.
8. Remove the spark plug cap and spark plug and pour
about a tablespoon of oil into the cylinder.
9. Pull the recoil slowly to crank the engine to
distribute the oil and lubricate the cylinder.
10. Reattach the spark plug and spark plug cap.
11. If the generator includes a battery, disconnect and
charge according to Generator Battery .
12. Clean the generator according to Generator
Maintenance.
13. Store the generator in a cool, dry place out of direct
sunlight.
Long Term Storage (over 1 year)
For storage over 1 year, the fuel tank and carburetor must
be completely drained of gasoline.
1. Be sure all appliances are disconnected from the
generator.
2. Add a properly formulated fuel stabilizer to the fuel
tank.
3. Run the generator for 10 minutes so the treated fuel
cycles through the fuel system and carburetor.
4. Run Dry Option:
a.
Let the generator run to fuel complete starvation.
b.
Turn engine switch to the "OFF" position.
c.
Allow generator to cool completely.
5. Drain Fuel Option:
a.
Turn engine switch to the "OFF" position.
b.
Allow generator to cool completely.
17.
Advertisement
Table of Contents
