Electronic Function - Makita GSH05 Instruction Manual

Electronic function

The tools equipped with electronic function are easy to
operate because of the following feature(s).
Soft start feature
Soft start because of suppressed starting shock.
Constant speed control
Electronic speed control for obtaining constant speed.
Possible to get fine finish, because the rotating speed is
kept constant even under load condition.
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Hex wrench storage
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
Fig.17
► 1. Hex wrench
Installing and removing circular saw blade
CAUTION:
installed with teeth pointing up at the front of the tool.
CAUTION:
install or remove the circular saw blade.
Installing circular saw blade
The circular saw blade may have already been installed
at the time of shipment.
1. Loosen the lever on the depth guide and move the base down.
2. Press the shaft lock fully so that the mounting
shaft cannot revolve and use the hex wrench to loosen
the hex bolt. Then remove the hex bolt and outer flange.
Fig.18
► 1. Shaft lock 2. Hex wrench 3. Loosen 4. Tighten
3.
Install the inner flange, ring (country specific), cir-
cular saw blade, outer flange and hex bolt. At this time,
align the direction of the arrow on the circular saw blade
with the arrow on the tool.
1
For tool without the ring
Fig.19
► 1. Hex bolt 2. Outer flange 3. Circular saw blade
4. Arrow on the circular saw blade 5. Inner flange
6. Arrow on the tool
12 ENGLISH
Be sure the circular saw blade is
Use only the Makita wrench to
4
1
1
2
3
4
5
6
2
3