Dip Switches On The Iserver; Figure 2.2 Dip Switches On The Iserver; Table 2.1 Rear Panel Annunciators - Omega iServer DPi8 User Manual

2.3 DIP Switches on the iServer

For Dipswitch access you must remove the main board from the case. Refer to the
Disassembly Instructions in your iSeries Monitor/Controller Quickstart Manual.
1 To change the IP address
from the serial port
2 To change to default factory
settings
3 To enable/disable DHCP
4 To enable/disable Terminal
Server function
The iServer is shipped with all
DIP switches in "OFF" position

Table 2.1 Rear Panel Annunciators

Serial Communication Interface Section (For Models with RS485):
Pin 10 -Rx/Tx
Pin 9 +Rx/Tx
Pin 8 Return, Common Ground Shield connection
Network Communication Interface Section:
ETHERNET RJ45 interface for 10BASE-T connection.
RESET Button: Used for power reseting the iServer.
COL / ACTIVITY LED (Red) Blinking: Indicates network activities (receiving or sending packets).
ON / NET LINK LED (Green) Solid: Indicates good network link.
TX LED (Yellow) Blinking: Indicates transmitting data to the serial port.
RX LED (Green) Blinking: Indicates receiving data on the serial port.
4 3 2 OFF
ON

Figure 2.2 DIP Switches on the iServer

1
5
4
3
2
1
OFF
ON