Table of Contents
Advertisement
the treadmill and place it against the wall. Ensure the treadmill is on an angle so that it
cannot be tilted to avoid falling.
Belt Lubrication
•
Disconnect the power before lubricating
the treadmill.
•
Lift the edge of the belt and apply 5-10ml
of silicone oil to the inner surface. Do not
apply too much oil as this may cause the
belt to slip.
•
Run the treadmill at 4km/h for
approximately 10-20 seconds.
•
Lubricate the belt every 3 months.
Applying lubricating oil between the running belt and running board of the electric walking
machine according to the following schedule:
•
Lightweight users: (less than 3 hours per week) once a month.
•
Heavyweight users: (over 7 hours per week) every half month.
Belt Adjustment
If the treadmill belt begins to slip or is out of
alignment, it will need to be adjusted. If the
running belt is too loose, there may be
slipping during running; If it is too tight, it
may reduce the performance of the motor
and exacerbate the wear of the drum and
running belt.
When the tension of the running strap is
suitable, you can lift both sides of the
walking strap by hand about 50-75mm
away from the running board.
• Start the treadmill and run it at a low speed (4km/h)
• To adjust belt to the left, turn the left adjusting screw clockwise by 1/2 turn.
• To adjust belt to the right, turn the right adjusting screw clockwise by 1/2 turn.
• To adjust belt tension, turn the left and right adjusting screws clockwise for 1/2 turn at
the same time.
• After each adjustment, run the treadmill for approximately (1-2 minutes) to observe if
the issue has been corrected. Adjust again if necessary.
Advertisement
Table of Contents
