Advertisement
Valve Seat Width Inspection
Remove carbon deposits from the combustion chamber. Inspect the valve
seats for pitting or other damage.
Standard
0.0315 - 0.0394"
(0.8-1.0 mm)
Cylinder Head Warp Inspection
- Remove carbon deposits from the combustion
chamber.
- Clean off any gasket material from the
cylinder head surface.
- Check the spark plug hole and valve areas for cracks.
- Check the cylinder head for warpage with a straight
edge and a feeler gauge as shown.
Service Limit
NOTE: If this measurement is out of specification, complete engine replacement is required.
The only internal parts available for this engine are gaskets and seals.
Service Limit
0.0787"
(2.0 mm)
0.00393" (0.10 mm)
FEELER GAUGE
23
3
STRAIGHT EDGE
Advertisement
Chapters
