Getting Started; Battery Removal And Installation - VTech Kidi Secrets Doodle Pad Instruction Manual

GETTING STARTED

The unit is in Try-Me mode in the packaging. Open the battery
cover, then press and hold the reset button for around 1 second,
the passcode will be cleared and the notebook cover will open. This
confirms that Try-Me mode has been exited.

Battery Removal and Installation

1. Make sure the unit is turned Off.
2. Locate the battery cover on the back of
the unit. Use a screwdriver to loosen the
screw and then open the battery cover.
3. If used batteries are present, remove
these batteries from the unit by pulling
up on one end of each battery.
4. Install 3 new AA (LR6/AM-3)
batteries following the diagram
inside the battery box. (For best
performance, alkaline batteries or
fully charged Ni-MH rechargeable
batteries are recommended).
5. Replace the battery cover and tighten
the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.
4