Midea MCD-18HRFN1-QRD0 Installation Manual page 27

2. Remove foam stops from inside the fan.
3. Attach the side of the front grille to the panel.
4. Connect the display panel cable to the
corresponding wire on the main body.
Control box
Fig. 10.5
CAUTION
Failure to tighten screws can cause water
leakage.
CAUTION
If the unit is not hung correctly and a gap
exists, the unit' s height must be adjusted
to ensure proper function. The unit' s
height can be adjusted by loosening the
upper nut, and adjusting the lower nut.
5. Close the front grille.
6. Fasten the installation covers at all four corners by
pushing them inwards. (See Fig.10.6)
NOTE: If the height of the indoor unit needs to be
adjusted, you can do so through the openings at the
panel' s four corners. Make sure that the internal wiring
and drainpipe are not affected by this adjustment.
Water condensation
Gap not allowed
Fig. 10.6
Fig. 10.7
Loosen upper nut
Adjust lower nut
Fig. 10.8
 Page 27 