Siemens HB378GA 0 Series User Manual And Installation Instructions page 21

17 Shelf supports
To clean the rails and the cooking compartment, or to
replace the rails, you can remove these.
17.1 Detaching the shelf supports
WARNING ‒ Risk of burns!
The shelf supports get very hot
Never touch the shelf supports when hot.
▶
Always allow the appliance to cool down.
▶
Keep children at a safe distance.
▶
Lift the rail forwards slightly
1.
2. Pull the whole rail to the front
17.2 Attaching the shelf supports
Notes
¡ The rails only fit on the right or left.
¡ For both pull-out rails, ensure that you can pull them
forwards and out.
First, push the rail into the middle of the rear
1.
socket ​ ⁠ until the rail rests against the cooking
compartment wall, and then push this back
Push the rail into the front socket
2.
also rests against the cooking compartment wall,
and then press this downwards
17.3 Removing the pull-out rail
WARNING ‒ Risk of burns!
The shelf supports get very hot
Never touch the shelf supports when hot.
▶
Always allow the appliance to cool down.
▶
Keep children at a safe distance.
▶
Notes
¡ Depending on the appliance type, you must change
the basic settings for the telescopic rails for appli-
ances with rails and pull-out rails.
→ "Basic settings", Page 16
¡ The pull-out rails can be installed at any level as re-
quired.
¡ If necessary, you can equip all levels with a pull-out
rail.
Push on the side of the tab marked PUSH behind
1.
the rail, and push the rail to the rear.
​ ⁠ and detach it ​ ⁠ .
​ ⁠ and remove it.
​ ⁠ .
​ ⁠ until the rail
​ ⁠ .
Press and hold PUSH
2.
wards ​ ⁠ until the front retainer
a
Pull the rail out towards the front.
3.
Remove the pull-out rail.
4.
Clean the pull-out rail.
5.
→ "Cleaning products", Page 17
Note:
Further information:
17.4 Attaching the pull-out rail
Note: The pull-out rails only fit on the right or left. Make
sure when you fit them that you can pull them out to-
wards the front.
Shelf supports en
​ ⁠ and swing the rail out-
​ ⁠ is detached.
21