Siemens HB378GA 0 Series User Manual And Installation Instructions page 20

Table of Contents

Advertisement

en cleaning assistance humidClean
Cleaning set-
Cleaning
ting
level
1
Low
2
Medium
3
High
Select a higher cleaning setting if the cooking com-
partment is particularly dirty or has not been
cleaned for a while.
The duration cannot be changed.
a After a few seconds, the cleaning function starts and
the duration counts down.
a For your safety, the appliance door locks once a
certain temperature is reached in the cooking com-
partment. ​ ⁠   appears on the display.
a When the cleaning function ends, a signal tone
sounds and the duration is at zero on the display.
Switch off the appliance.
3.
16  cleaning assistance humidClean
The cleaning assistance is a fast alternative for occa-
sionally cleaning the cooking compartment. The clean-
ing assistance softens dirt by vaporising the soapy wa-
ter. The dirt can then be removed more easily.
16.1 Setting the cleaning assistance
WARNING ‒ Risk of scalding!
If there is water in the cooking compartment when it is
hot, this may create hot steam.
Never pour water into the cooking compartment
when the cooking compartment is hot.
Requirement: The cooking compartment has cooled
down completely.
Remove the accessories from the cooking compart-
1.
ment.
Mix 0.4 litres water with a drop of washing-up liquid
2.
and pour into the centre of the cooking compart-
ment floor.
Do not use distilled water.
Use the function selector to set the Bottom
3.
heating  ​ ⁠ type of heating.
Use the temperature selector to set 80 °C.
4.
Press the
​ ⁠ button repeatedly until
5.
in the display.
Use the
​ ⁠ or
​ ⁠   button to set the time to
6.
four minutes.
a After a few seconds, the appliance starts heating
and the cooking time counts down.
20
Duration in hours
Approx. 1:15
Approx. 1:30
Approx. 2:00
​ ⁠ is highlighted
When the appliance has cooled down sufficiently,
the appliance door is unlocked and ​ ⁠   goes out.
Prepare the appliance for use. → Page 20
4.
15.3 Preparing the appliance for use
following the cleaning function
1.
Allow the appliance to cool down.
Wipe off any ash that has been left behind in the
2.
cooking compartment and around the appliance
door with a damp cloth.
Remove white residues with lemon juice.
3.
Note: White residues on the enamel surfaces may
be caused by heavy soiling. These food residues
are harmless. The deposits do not compromise the
functionality of the appliance.
Attach the shelf supports.
4.
→ "Shelf supports", Page 21
a When the cooking time has elapsed, a signal
sounds and the duration is at zero in the display.
Switch off the appliance and leave the cooking com-
7.
partment to cool down for 20 minutes.
16.2 Recleaning the cooking compartment
ATTENTION!
The prolonged presence of moisture in the cooking
compartment leads to corrosion.
After using the cleaning assistance, wipe the cook-
ing compartment and allow it to dry completely.
Requirement: The cooking compartment has cooled
down.
1.
Open the appliance door and remove the remaining
water with an absorbent sponge cloth.
Clean the smooth surfaces in the cooking compart-
2.
ment with a dish cloth or a soft brush. Remove stub-
born food remnants using a stainless steel scouring
pad.
Remove limescale with a cloth soaked in vinegar.
3.
Then wipe with clean water and rub dry with a soft
cloth (including under the door seal).
Once the cooking compartment is cleaned suffi-
4.
ciently:
To allow the cooking compartment to dry, open
the appliance door to the stop position (approx.
30°) and leave it open for approx. one hour.
To dry the cooking compartment quickly, heat up
the appliance for approx. five minutes at 3D hot
air  ​ ⁠ and 50 °C while the door is open.

Advertisement

Table of Contents
loading

Table of Contents