Wall Mounting - ElectiQ VD4-1600-1.2BW User Manual

WALL MOUNTING

NOTE: Depending on your wall type alternative fixings may be required to secure the
heater to your wall. If in any doubt advice should be sought from a competant person.
Measure the distance between the two columns that you will be hanging your
heater from on the top of the heater and the two ends on the bottom of the rail.
Step Then measure the distance vertically between the top and bottom holes. Make a
1 note of the measurement, and mark four points on the wall that distance apart.
Use a spirit level to ensure that they are level.
Drill 4 holes into the
wall in the positions
marked using a
Ø10mm drill bit and
insert the wall plugs
provided. Secure
the brackets to the
wall using the
screws and washers
Step
provided with the
2
grooves all facing
upward, then insert
the bracket covers
onto the grooves.
Ensure that the
brackets are secure
before commencing
onto the next step.
Step Carefully hang the radiator onto the brackets. It is highly recommended that two
3 people perform this step, due to the weight of the radiator.
Page 8 of 31