Wall Mounting - ElectiQ HS10-600-0.6DGW User Manual

WALL MOUNTING

NOTE: Depending on your wall type alternative fixings may be required to secure the
heater to your wall.
Measure the distance between the two columns that you will be hanging your
heater from on the top of the heater and the two ends on the bottom of the rail.
Step Then measure the distance vertically between the top and bottom holes. Make a
1 note of the measurement, and mark four points on the wall that distance apart.
Use a spirit level to ensure that they are level.
Drill 4 holes into the
wall where you
have marked using
a Ø10mm drill bit
and insert the wall
plugs provided.
Secure the brackets
to the wall using
the screws and
Step washers provided
2 with the grooves all
facing upward, then
insert the bracket
covers onto the
grooves.
Ensure that the
brackets are secure
before commencing
onto the next step.
Step Carefully hang the radiator onto the brackets. It is highly recommended that two
3 people perform this step, due to the weight of the radiator.
Page 8 of 26