Wall Mounting - ElectiQ HS24-600-2DGW User Manual

WALL MOUNTING

NOTE: Depending on your wall type alternative fixings may be required to secure the
heater to your wall.
Measure the distance between the two columns that you will be hanging your
heater from on the top of the heater and the two ends on the bottom of the rail.
Step Then measure the distance vertically between the top and bottom holes. Make a
1 note of the measurement, and mark four points on the wall that distance apart.
Use a spirit level to ensure that they are level.
Drill 4 holes
into the wall
where you
have marked
using a
Ø10mm drill
bit and insert
the wall plugs
provided.
Secure the
brackets to
the wall using
the screws
provided with
Step
the grooves
2
all facing
upward, then
insert the
bracket
covers onto
the grooves.
Ensure that
the brackets
are secure
before
commencing
onto the next
step.
Step Carefully hang the radiator onto the brackets. It is highly recommended that two
3 people perform this step, due to the weight of the radiator.
Page 7 of 24